Maykke HJA1080101 User manual

REV.07072017SPECIFICATION SHEET www.maykke.com
SPECIFICATION SHEET
All measurements are approximate and may vary +/- 1/4"
Model: HJA1080101/HJA1080102 Deck-Mount Tub Filler with Hand Shower
Side
7 ”
2 ”
5 ”
5”
3 ”

www.maykke.com
Deck Mount Tub Filler
Installation Guide

TOOLS NEEDED:
PARTS INCLUDED:
RECOMMEND TOOL:
ScrewdriverPlierGlue Monkey Wrench Wrench
REV.10232017INSTALLATION GUIDEwww.maykke.com
INSTALLATION GUIDE
Notice: Before beginning please read all installation instructions and observe all local safety and build-
ing codes.
Notice: Inspect all products before installing.
Notice: Consult a professional if you are unfamiliar with faucet installation. We accept no liability for
damages to property or person during installation.
Notice: Insure that the waterline is clean and clear of debris before beginning.
Notice: Make sure water is turned o before beginning.
PLUMBER’S TAPE

REV.10232017INSTALLATION GUIDEwww.maykke.com
INSTALLATION GUIDE
1. Remove the locknuts from all faucet trim pieces.
(If your model has the diverter built into the spout, you
will need to unscrew the diverter from the back of the
spout before proceeding)
2. Insert the faucet components through the mounting
holes and tighten the nuts. Making sure the cold valve is
on the right, hot valve is on the left. (replace the diverter
from step one)
3. Connect the supply lines, using plumber’s tape, to both
the hot and cold valve connectors, then to the main
faucet connector.
H C
H C

REV.10232017INSTALLATION GUIDEwww.maykke.com
INSTALLATION GUIDE
6. Connect the large end of the handshower hose to the
hand shower (using plumber’s tape) and feed the smaller
end through the mounting trim.
4. Tighten using a wrench.
5. Using the other two supply lines connect the water
lines, cold to cold and hot to hot. Insuring to use
plumber’s tape on all threads.
Hot
Cold
H C

REV.10232017INSTALLATION GUIDEwww.maykke.com
INSTALLATION GUIDE
7. Open the hose weight by loosening the screw. Feed
the handshower hose through the weight and tighten the
screw to secure.
8. Using plumber’s tape connect the small end of the
handshower hose to a water supply hose and then
connect the hose to the centerline of the faucet spout.
9. Turn water on to test.
For warranty information please check www.maykke.com
For customer service concerns or support please email: [email protected]