Meridian 4X4X4 DOME Router User manual

Content of the parcel:
When you install:
INSTALLATION MANUAL
1
4X4X4 DOME Router,
Panel Version
4 ea. Antenna-Modem Panel (optionally 4 pairs of mounting brackets)
(Our eSIM profile loaded to SIM slot #1. Sim slot #2 is externally accessible
for you to insert a physical SIM card.)
1 ea. Control-Router
4 ea. Data cable 2.0m (USB3.1) to connect the panels to the control router
(please use the blue USB3 ports, not the black USB2 ports. The latter are for
support purposes only.)
1 ea. PSU AC (110..240V, 280W) to 24V/ 10A DC (in case you don’t have DC
available in the existing dome), including 1 ea. Power cable EU to IEC13.
•
•
•
•
The dimensions of the panels are: 300 x 145 x 31 mm.
Control Router: 220x170x76mm (mounted flat in the dome’s base).
Please make sure that the panels are attached to the inner sides of your
dome in the upright position (vertically or horizontally). Before permanently
fixing the mounting brackets/ panels please check that the distance
doesn't exceed the cable's length.
Note: Do not use any metal parts (e.g. screws or bolts) to fix the panels - this
would interfere with the RF path.
Please see a picture showing an installation inside a dome attached. Here is a
video as well so you can get an idea:
https://youtu.be/M_Rhf0lbVcQ
Note: The system will power up automatically, once AC or DC connected.

4X4X4 DOME Router, Panel Version INSTALLATION MANUAL 2
Ethernet-Port configuration:
Note: There is no DHCP enabled. Please use static IP assignment for your laptop
and border router/firewall
ETH0
(left most one, marked in Yellow)
IP: 172.20.70.1/24 (net mask 255.255.255.0)
Please connect this one to your ship’s firewall/ network
ETH1
(right most one)
IP: 10.10.100.253/24 (net mask 255.255.255.0).
This one is meant for support purposes only.

4X4X4 DOME Router, Panel Version INSTALLATION MANUAL 3
Regional and carrier specific Firmware selection
(US only):
UI -> SETTINGS -> Advanced.
Generic (preset) is working almost everywhere.
Some US cards will require swapping to carrier specific firmware.
Carrier, Data Mode and APN selection:
UI -> SETTINGS -> Router Configuration.
Most of the time “automatic” is the best choice.
If you want to force differently, please disable automatic (toggle button) and
make your choice.
Access to the Dome’s UI (user interface):
url: http://172.20.70.1 (assuming you are connected via ETH0)
username: shipadmin
password: ship
UI manual:
UI -> SETTINGS -> User interface manual.