MILL TH350 User manual
INSTRUCTION MANUAL (EN)
This assembly and instrucon manual applies to the following models:
TH350
Series: Climate
Read the instrucons carefully. Use and maintenance must also be in accordance with the instrucons. Quesons related to installaon or
use of the product should be addressed to the importer.
Important safety informaon
You must follow standard safety guidelines when using electrical products, especially in the presence of children.
WARNING
! To avoid electric shock or damage, always make sure that the plug is disconnected before the product is moved or
cleaned.
Read the instrucons carefully.
Make sure the product is connected to regular mains (230 V), as indicated on the product label.
Be parcularly careful if the product is used in the presence of children, the handicapped or elderly.
Make sure the cord is situated so that nobody can trip on it.
The product must not be used if either the cord or plug is damaged. The product must not be used if it has been
dropped on the oor or is damaged in any other way which causes it to malfuncon.
Avoid using extension cords, as such a cord may become overheated and possibly start a re.
If the cord is damaged, it must be repaired by the manufacturer or by an authorized technician to avoid dangerous situaons.
Never touch the product with wet hands, as this may cause electric shock.
The product must be switched o and the plug must be disconnected before the product is moved.
Do not insert your ngers or other objects into the air outlet on the top of the product.
Avoid overloading the mains (the circuit) where the product is connected. Pay aenon if other electrical apparatus are con-
nected to the same power outlet or circuit.
Do not place the product in close proximity to heat sources (electric radiator, replace, etc.). For best results the product
should be placed at least 10 cm from the wall.
Indoor use only. Do not use outdoors.
The product should be placed on a rm and at surface which is at least 60 cm above the ground.
Do not direct the steam outlet directly at the wall. It can damage the wall.
Never move the product when it is in use.
High humidity in a room can cause condensaon on windows and certain furniture. Turn o the product if this happens.
The product cannot be used by children under 8 years of age and persons with reduced physical or mental abilies or who
lack experience and knowledge of the product, unless they are given supervision or instrucon in the safe use of the device
and understand the hazards involved.
Children should not play with the device. Cleaning and maintenance should not be performed by children without supervision.
Children under 3 years of age should be kept away from the device, unless under connuous supervision.
Children aged 3 to 8 years are only permied to turn the device ON/OFF, assuming the device is assembled according to
the assembly instrucons and the children have received instrucon or supervision in the safe use of the product and un-
derstand the hazards involved.
EN 2 millclimate.com
KEEP THIS INSTRUCTION MANUAL FOR FUTURE USE!
NEVER TOUCH THE PRODUCT WITH WET HANDS OR COVER THE STEAM OUTLET
Model TH350
Product # CF-2806
Color White
Capacity 350 ml/hour
Control panel Electronic touch
Waage 30 W
Working area 30–50 m2
Tank volume 4.1 liters
Speed levels 3 (low/medium/high)
Nightlight Yes (ON/OFF)
Timer sengs 2.4 and 8 hours
Dimensions (W × D×H) 17 ×17 ×28.5 cm
Specicaons
EN 3 millclimate.com
Descripon of the product
Before use
1) Make sure that the product is turned o and not plugged in.
2) Place the product on a rm and at surface, at least 60 cm above the ground, and at least 10 cm away from the wall.
As you need to ll the product with water at regular intervals, we recommend that you think carefully about where to
place the product, considering that water may be spilled on the furniture.
3) Fill the water tank:
A. Take out the water tank by liing it straight up (see the gure on the previous page)
B. Remove the screw cap (turn counterclockwise) on the boom of the water tank.
C. Fill the tank with cold water (Do not ll the tank with hot water because this can result in leakage)
D. Put on the screw cap and make sure that this ts well
E. Turn the water tank and put it back in the ultrasonic device (see the gure on the previous page)
F. The water tank will automacally deliver water to the unit.
4) Make sure the product is connected to regular mains (230 V), as indicated on the product label.
EN 4 millclimate.com
Instrucon manual for TH350:
Control panel and use:
A) ON/OFF buon. Press once to turn the product ON or OFF.
B) Nightlight ON/OFF (only visible in a dark room).
C) Timer funcon (counng down unl the product is switched OFF).
i) Press the clock to acvate the mer funcon for either 2, 4 or 8 hours.
Ii) For connuous operaon none of the lights 2, 4 or 8 will be lit.
D) Speed level of the fan for steam (low/medium/high).
E) Water tank is empty (the light will ash if the water tank is empty). The product automacally
turns itself o when the water tank is empty.
CAUTION! The control panel is
touch-sensive.
EN 5 millclimate.com
Problem Cause Correcve measure
The unit is not working
The product is not receiving power Connect the plug to the socket and check
The product is not switched on Turn on the product
The light indicang empty water
tank is lit Please ll the water tank with cold water
The steam produces an undesirable
odor
New machine
Unscrew the screw cap on the water tank and
leave the water tank open for 12 hours in a cool
place
Dirty water or water that has been
le in the water tank for a long
me
Clean the tank and ll it with clean, cold water
The control panel is lit, but the
product does not switch itself on
Too much water in the ultrasonic
unit
Disconnect the product from the energy source
and empty water from the ultrasonic unit
Less steam than usual The ultrasonic membrane is dirty Clean the ultrasonic-membrane with a small brush
(included). (The membrane is located in the middle
of the ultrasonic device and is shiny and round,
surrounded by a lot of material.)
Abnormal sound Resonance in the water tank when
the water level is low
Pour more water into the water tank
Abnormal sound The products is unstable Move the product to a rm and at surface
Troubleshoong
Please go through the troubleshoong guide to idenfy what can be done to correct the problem.
Contact Mill Internaonal AS should the problem persist.
EN 6 millclimate.com
Maintenance and storage
Make sure the power connector is unplugged before maintenance.
Daily maintenance
It is recommended that you ll the tank with fresh water every day for opmum indoor climate. Empty the water tank com-
pletely and ll it again with fresh water.
Weekly maintenance
- Fill the boom of the ultrasonic device (center) with a cup (ca. 200 ml) of white vinegar for 15 minutes.
- Use the brush to clean any impuries (parcularly from the ultrasonic-membrane in the center).
- Remove the vinegar and rinse repeatedly with cold water.
CAUTION!
- Make sure that the ultrasonic device is never submerged in water.
- Do not use aggressive detergents to clean the product.
- Use only a so cloth to clean the inside of the product.
- Use only the included brush to clean the ultrasonic membrane. This should be done at least once a week.
- Change the water in the water tank at least once a week.
Storage
- Clean the product as described under “Weekly maintenance”. Make sure that the product is dried suciently.
- Store the product in its original packaging.
- Avoid high temperatures.
EN 7 millclimate.com
Warranty
The warranty is valid for 2 years. The product will be repaired or replaced during this me should any malfuncons occur.
The warranty applies if the product is used according to these instrucons and the customer can present a purchase receipt.
In case of any product failures, please contact the store where it was purchased or the importer.
Waste disposal
The symbol indicates that this product is not to be disposed of together with household waste. This product must be
delivered to a recycling service for electrical appliances and electronic equipment. This is done to avoid health risks and pre-
vent harm to the environment. Your local ulity, business or environmental center has an arrangement to ensure the envi-
ronmentally correct disposal and recycling of such products.
When subming a claim, you have to provide the series number
for your product and present the original receipt.
In case of claims or quesons about the product or spare parts, contact your retailer or Mill Internaonal AS
Mill Internaonal AS
Grini Næringspark 12
1361 Østerås
Tel.: +47 22 13 32 00
facebook.com/millheat
millclimate.com / millheat.com
EN 8 millclimate.com
Table of contents
