Mobi-click A-136 User manual

The device has
been installed in
BMW 528. At first
you should check
on the basis of a
guide book of the
respective car,
where the fuse
panel is situated.
The power supply
will be connected
there (see the
page 10, pkt. 11 of
our instruction
manual).
Installation reference for the installation of the device
Mobi-Auto A-136

In the picture 2 you can see, which components must be installed. The power
cable, the GPS receiver and the remote control haven’t been shown in the picture.

At first the microphone has been installed top left near the sun visor (picture 3).
For this purpose the cable has been installed under the side panelling.

The side panelling on the frame can be removed easily. Also the LED has
been installed on the same side (see the picture 4).

The loudspeaker should be installed near the driver seat. Good
location is the storage place in the centre console (picture 5).

The control unit with the GPS receiver and antenna we have installed near the other car control
units. For this purpose we had to undo 2 screws to remove the clap (picture 6). Under the clap there
is a lot of place, so that the control unit and the GPS receiver have been placed there. We didn’t
have to fix the device with any screw, because it could be built in very solid. As soon as the clap will
be closed again, the control unit can’t move any more. Also the GPS antenna has a very good
reception area in this hollow space, so that a good place has been found there.

Just after all accessory items have been installed in a right way, the control unit
can be connected to the fuse (picture 7 and 8 resp. see our instruction manual
page 11 and 12).

Picture 8

Pictures 9 and 10 show that the device and the accessory items have been built
in very good without any interference of the visibility range of the driver.

Good LuckPicture 10