Mod Skye User manual
Step 1: Drill holes according to the base
plate hole spacing.
Step 2: Embed the expansion screws
into the intended holes to fix it to the floor.
If you have any questions or experience any issues with your installation,
Design Drawing
Installation Notes:
1. Suitable for 90-260V.
2. Make sure the electricity is powered off before installation or cleaning.
3. Please test the fixture before installing to ensure that there is no problem with the fixture itself before installing onto the ceiling.
4. Please wear gloves during installation process to avoid scratches.
Skye Installation Guide
Modern Outdoor Lamp
If you have any questions or experience any issues with your installation,
Precautions and Maintenance
1. The solar panel should be installed in a location where it receives direct sunlight.
Otherwise, insufficient charging may occur.
2. During installation, avoid scratching the surface of the lamp and the wires. Wear gloves
when installing.
3. Avoid frequently switching the power supply during the use of the lamp to prevent
damage to the lamp.
4. After installing the lamp, please read the remote control user manual carefully.
5. If the lamp does not turn on, it may be due to low battery power. Charge the lamp under
sunlight before use.
6. The operating temperature range for the solar system is -15°C to 70°C. The system will
not work if it exceeds this range.
7. The lamp head has light-sensing capability. Ensure that no other light source covers the
solar panel. Even if the lamp has power, it will not light up.
To ensure safety, the installation of this lamp must be carried out by
professionals. All bolts, nuts, and screws subjected to force must be
tightened securely.
Skye Installation Guide
Modern Outdoor Lamp
ON
Instructions:
1.Before using the remote control, please remove the transparent
partition.
2.The remote control is not effective during the daytime and can
only be used at night.
3.The timed light-on duration and brightness level have a memory
function. After turning off the light, when it is turned on again, it will
execute the previous timed light-on duration and brightness level.
This repeats daily.
Remote Control Instructions
Function Description
Turn on the light:
Default mode: The light stays on for 12 hours with decreasing
brightness in timed intervals.
Turn off the light:
Timed light on for 2 hours.
Timed light on for 4 hours.
Timed light on for 6 hours.
Timed light on for 8 hours.
Decrease brightness.
Increase brightness.
REMOTE CONTROL INSTRUCTIONS
ON
OFF
2H
4H
6H
8H
2H
OFF
TIMER
DIM
4H
6H 8H
If you have any questions or experience any issues with your installation,
Table of contents
