MonLines MWH003B User manual

EN
Be sure to read the assembly instructions before assembly - installation - commissioning! This will protect you and prevent damage to your product.
1. Scope of delivery
Before the actual installation, please note the following instructions for proper installation:
1. This bracket is designed to be installed and used only as specified in this manual.
as specified in this manual. Improper installation of this product may cause damage
or serious injury.
2. This product should only be installed by a person with skilled craftsmanship and basic
knowledge and experience in assembling.
3. Ensure that the surface on which the bracket is to be mounted can support the total load of
the unit and all components connected to it.
4. If you are mounting the bracket on a wooden stud wall, make sure that the
bracket screws are fastened in the centre of the joists. It is recommended to use a joist
finder.
5. For safety reasons, only lift and position equipment in pairs or with a mechanical lifting
device.
6. Tighten bolts firmly, but do not overtighten them. Overtightening can damage the
components and significantly reduce their holding power.
7. This product is intended for indoor use only. Use outdoors may result in product failure
and personal injury.
2. Assembly preparation
Make sure that you have received all the parts included in the delivery before you start the
assembly. If any parts are missing or defective, please contact your dealer.
MonLines MWH003B
Swivel TV wall mount up to 55 inch
Assembly instructions

MonLines | Am Marienhof 8, 22880 Wedel - Germany | T. +49 4103 - 903 87 00 | F +49 4103 - 903 87 11 | [email protected] | www.monlines.com
3. Mounting on wooden or stone walls
Wooden wall
Stone wall
4. Attaching VESA braces to TV
TV with flat back panel
TV with curved back panel (Curved)
5. Hanging and fastening the TV
6. Adjusting the tilt and swivel angle