
Caution: -Default frequency is 87.5 MHz
-If the set frequency is close to the frequency of other radio stations around, causing
interference noise, please replace other frequencies without interference
-In FM transmit mode, the EQ effect cannot be changed
FAQ
1.How to turn on the player?
Please slide the power switch to ON position to playback. When a disc is played to the end the
player will enter a standby mode after 20 seconds (In the default playback mode of the boot). You
can press the button” ” to restart the player. You can also turn off the power switch and then
turn on the power switch to restart.
Note: Please turn the power OFF to reduce power loss if the CD player will no longer be used
for a long time.
2.How to connect the CD player to a car or speaker with an AUX port?
There is a 3.5mm AUX audio cable with a male plug on each end in the package. One goes into
the Headphone jack, the other plugs into alternative input.
3.Why can't the CD player play the disc?
1.Disc format is not supported, it’s just for CD, CD-R, CD-RW, and music format just support
CD-DA, MP3, WMA, Disc format and music format need to be met at the same time
2. Please check if the batteries have low power or check if the power adapter is well connected.
Besides, the condition of the disc (scratches, dirty, debris, cracks, etc.) will cause equipment
malfunction or shorten the life of the laser head. So please check your CD condition, and try a
new CD to have a test.
Specifications and parameters:
Support disc type: CD, CD-R, CD-RW
Support music format: CD-DA, MP3, WMA
Power source: DC 5V/1A
Battery: Lithium-ion polymer, 3.7V
-charge time:3h, When fully charged, the indicator light will change from red to blue
Frequency response:20-20k Hz