MORPHO MORPHOALP ULTRA LIGHT User manual

1. Untighten ankle strap (by loosening completely the
Buckle
strap from the buckle of the strap) as well as the toe strap
so as
to insert your boots and to adjust the heel thrust of
articulated
binding plate to your boot size. See Fig.3
2. Place the toe of your boot against the front part of the
articulated binding plate, inside the toe strap, making sure the
webbing of the forefront strap is above your boot.
3.
Adjust the heel thrust to the proper size of your boot using the
Morpholock system. See Fig.2:
3a-raise the size adjust lever with the help of logo
rubber tab
puller and move the heel thrust on the binding to the proper
size of your boot: the heel of your boot must touch the back of
the heel thrust for perfect maintaining of the boot while
snowshoeing
3b-when size is correctly adjusted release the rubber tab:
the heel thrust is then locked in the binding slots thanks to the
teeth of the size adjust lever.
4. Your boot is then well adjusted lengthwise: start tightening
the toe strap firmly by pulling the printed webbing after
insertion in the two holes quick buckle. Due to the flexible
material of the binding front lateral parts your boot perfectly
fits the binding.
5. Insert the loosened strap (step1) inside the two holes of the
buckle of the ankle strap around your boot then tighten the
ankle strap by pulling the strap until you feel firmly
tightened.
6. Snowshoeing: keep articulated binding plate free from
snowshoe base when going flat, traverse, uphill or downhill: the
RTS unlocked from base locker/step in all cases. The
articulated binding must lay flat on the snowshoe base or
stepping on the extra high metallic climbing step when
climbing steep slopes: for this purpose rotate the climbing step
forward in its upwards position (fig.3) from its idle position
(fig.2) with your gloves.
7. After use, untighten ankle strap first: pull up the buckle
of
the strap and pull out the ankle strap from the buckle. Then
untighten the toe strap
: pull up the end of the quick buckle and
loosen the webbing. See fig 3. Remove your boot. To store
the
snowshoe push the articulated binding
on the base and lock it to
the base by rotating the RTS so as to insert it into the base
locker/step. See fig.2
8. ALWAYS rinse
snowshoes with water and brush to remove
mud and debris after every use.
Fig.2 Size adjust lever Logo rubber tab puller
.MORPHO® snowshoes don’t have a right or left
snowshoe. MORPHO recommends to wear the
snowshoes so that the ankle ratchet buckle and toe
strap
buckles are on the outside of the foot so as to tighten
ankle and toe straps in the easiest way.
.Kneeling on one knee and wearing the other foot
snowshoe is the best position to be
when putting on the
snowshoes. This gives you the best grip and leverage
for inserting and tightening the straps.
.Ankle and toe straps must firmly tightened around
your boot
.When rotating backward metallic climbing step to its
idle position make sure to fully push it down until it is
blocked by the snowshoe base rear hook. (fig.2)
.Do not snowshoe on rock or concrete, this causes
excess wear: take off snowshoes until you are back on
snow.

. Buckle type ankle strap with quick buckle
.Extra high metallic climbing step, 5,6cm height
.Binding locker: easy switch RTS with gloves
.Stainless steel 2mm thick front knives
MORPHOLOGIC 2D waist concave side cut:
Contact surface: 2 x 1170 cm2,
Weight per pair: 1.6 Kg
Length: 65, max. width: 25, min. width: 19cm
GENERAL:
.Material: polypropylene copolymere base,
Polyamid 66
rigid articulated binding, polyacetal quick lock buckle
type toe straps, 6 metallic spikes perfect grip
.Base structure with “X” vertical stripes providing best
grip uphill, downhill and in traverse.
. Accepts all types of boots from 19 to 35cms,
(graduation on the binding),
. Very easy boot size adjust Morpholock system.
. Garanteed 2 years down to -38°C, shock resistant.
MORPHO snowshoes have a 2 years limited
warranty. Should this
product fail during the warranty period we shall repair it o
r replace
it at our option, free of charge. This warranty applies to materials
and workmanship, excluding wear and tear. Repairs due to
improper use or care, negligence, product modification, or
accident are not covered under this warranty agreement, but will
be performed at a nominal charge on request. This warranty
applies only to the original purchaser. Proof of purchase is
required. Products purchased from an independent dealer should
be returned to the dealer for forwarding to MORPHO. Shipping
cost to MORPHO is the responsibility of the purchaser. Return
postage will be paid by MORPHO. Except as provided herein,
MORPHO makes no warranties, express or implied including
but
not limited to the implied
warranties of merchantability and fitness
for a particular purpose. MORPHO shall not be liable for any
consequential or incidental corporal damage whatsoever. This
warranty gives you special legal rights. You may also have other
rights which vary state to state. For more product or safety
information contact MORPHO: [phone],
[email protected]
ACCESSORIES
BAG for MORPHO shape
REF.: 10MHHOUS
MORPHOALP ULTRA LIGHT
Snowshoe
People between 60 and 96 kgs,
UNISEX
ALL TERRAINS, RENTAL
www.morpho.tm.fr
REF. 12MHRAQVUAB Fig. 1