MANUAL MODE OPERATION
After it is powered up, the trolling motor will operate in
Manual mode by default or if the GPS signal is lost while
operating in a GPS mode. To change from any function to
the Manual mode, press the Manual mode button ( ).
SPEED CONTROL
• To start the propeller, press the Propeller ( )
• To stop the propeller, press the Propeller ( ) button
• To increase motor speed by one level, press the
Increase Speed ( ) button
• To decrease speed by one level, press the
Decrease Speed ( ) button
Holding the Increase Speed or Decrease Speed button will cause the
speed level to increase to the maximum speed level or decrease to the
minimum speed level.
STEERING
• To turn left, press the Steer Left ( ) button
• To turn right, press the Steer Right ( ) button
The available steering range allows the trolling motor to turn beyond
180° for operation in reverse
GPS MODE OPERATION
Status LED is solid when the motor has GPS x.
Status LED blinks slowly when a GPS mode is active.
SETTING THE ANCHOR POSITION
• Press the Anchor ( ) button to lock current
GPS position
ADJUSTING THE ANCHOR POSITION (JOG)
While in Anchor, the Anchor position can be adjusted in
ve foot increments (Jog), relative to boat orientation, in the
direction selected:
• Press the Left arrow ( ), Right arrow ( ),
Forward ( ) or Backward ( )
STORING AN ANCHOR POSITION
• Press and hold any of the numbered Memory ( 1-8 )
buttons for two seconds
A stored Anchor position can be overwritten with a new Anchor position
by repeating the same procedure.
RECALLING A STORED ANCHOR POSITION
• Press and release the desired Memory ( 1-8 ) button
If the desired stored Anchor Position is over a mile away from your
current location, the trolling motor will emit an error tone.
EXITING ANCHOR POSITION
• Press the Anchor ( ) button or press the
Manual Mode ( ) button
SETTING THE HEADING LOCK
To lock in the trolling motor’s heading and navigate in a
straight line:
• Steer the trolling motor in the desired direction
• Press the Heading Lock ( ) button
ADJUSTING HEADING LOCK
The Heading can be adjusted using the Steer Left and Steer Right buttons.
The speed can be adjusted by using the Increase and Decrease Speed
buttons.
EXITING HEADING LOCK
• Press the Heading Lock ( ) button or the
Manual Mode ( ) button
RECORDING AND STORING A ROUTE
• Press the Route Record ( ) button and begin
navigating along your desired Route
You can use Heading Lock and Manual mode at any time while
recording a Route. Status LED will blink and unit will beep as waypoints
are recorded.
• Press and hold any of the numbered Memory
(
1-8 ) buttons to stop recording and to store the Route
The trolling motor will emit a tune to confirm that the Route is stored.
To overwrite a stored route, use the same procedure as Storing a
new Route.
RECALLING A STORED ROUTE
• Press the Route Playback ( ) button
• Press and release the desired numbered Memory ( 1-8 )
button
The trolling motor will return you to the nearest point on the recalled
Route then navigate the longest leg of the route.
ROUTE TRAVEL AND COMPLETION
While travelling along a stored route, the direction of travel can be
reversed by recalling the stored route again.
Upon reaching the end of a stored route, the system will enter
Anchor mode
SETTING CRUISE CONTROL
• Press the Cruise Control ( ) button to set the
Cruise Control at 1.0 mph
Cruise Control can be activated while in Heading Lock or Route Playback.
ADJUSTING CRUISE CONTROL SPEED
• Cruise Control ( ) speed can be increased
or decreased in 0.1 mph increments by using the
Increase Speed ( ) button or Decrease
Speed ( ) button
EXITING CRUISE CONTROL
• Press the Cruise Control ( ) button to turn off
Cruise Control
Learn more about boat parts and hardware we have.
