Moultrie Welder User manual

Instructions for Pro-Line Directional Feeder
Directional Feeder will mount to the bottom of any drum or bucket.
Turn Drum upside down.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna •Increase the separation between the equipment and the receiver
Place Feeder on Drum. Attach
Feeder Legs to drum as shown
with large Bolts using nuts and
washers provided.
MOUNTING THE FEEDER
DRILLING YOUR DRUM/BARREL/BUCKET
FeederLegHoles
Funnel Holes
Turn drum over, measure and mark the center of the bottom.
Center the template on the bottom of the drum and secure
with tape. Drill two 3/16" Funnel holes and three 5/16"
Feeder Leg holes.
Using a Hole Saw, drill a 2-1/4" hole in the center of the
bottom of your drum.
THANK YOU for your purchase of the Pro-Line Directional Feeder
Kit, a top quality Moultrie product. Please read both sides of this sheet
before operating this unit. If you should have any questions about this or
any other Moultrie product, please contact us using the information on the
reverse side. To help us to better serve you, please complete and mail
the enclosed Warranty Card.
Feeder
Feeder Legs
Drum
Long
Bolts
c a u t i o n: wea r ey e pr ot ec t i on
Place Funnel inside Drum with
small end of funnel facing down.
Attach with two Short Bolts
using nuts and washers provided. Drum
Bolts
Funnel
Short
Bolts

Our Service Department will gladly answer any questions you have.
Call 205-664-6700 Monday _Friday, 8:00 AM to 5:00 PM CST.
www.moultriefeeders.com
HEARTBEAT
The Heartbeat LED will
flash every 10 seconds if
the battery and feeder are
operating correctly.
Light Sensor
The light sensor
needs to be
unobstructed for
proper operation.
RUN Time Control Knob
Adjust the amount of feed
dispensed by adjusting the
knob to the desired number
of seconds.
TEST Button
CONFIGURING THE FEEDER
INSTALLING THE BATTERY
TIPS AND POINTERS
Expansion Port
Your Pro-Line Feeder is equipped with an
Expansion Port that will accomodate existing and
future upgrades such as programmable timers.
EVENING
HEARTBE
RUN
TES
EVENING
HEARTBEAT
RUN
TEST
Black
Alligator
Clip
Red
Alligator
Clip
Press and release this
button to test your feeder.
After three seconds your
feeder will cycle for the
duration set on the RUN
time control knob.
1: (Q) When should I fill the drum on my feeder? (A) To
prevent damage to the feeder kit, do not load drum until unit is
off the ground.
2: (Q) I have a hanging feeder. What should I hang it with and
how high should I hang it? (A) Some animals will chew through
products like rope, so chain or steel cable is best. The bottom of
the feeder should be about 7 feet from the ground.
3: (Q) What kind of feed should I use for deer, turkey, etc.?
(A) Shelled kernel corn is recommended. Shelled kernel corn
mixed with soybeans or pellets is also effective for attracting
deer. NOTE: When not mixed with corn, some pellet type feeds
can take on moisture and clog the feeder.
4: (Q) What kind of feed should I use for fish? (A) Floating
fish food is recommended. Larger pelletized food can cause jams
in the shroud.
5: (Q) How long should I set the feeder to run? (A) Many
customers find that 4 or 5 seconds is long enough to establish a
feeding pattern.
6: (Q) Some of the feed in the bottom of my drum never seems
to move, and may be getting moldy. Any solution? (A) For 30
and 55 gallon barrels, Moultrie has developed internal funnels to
solve this problem. The part numbers are MFH-FUN30 for a
30-gallon drum and MFH-FUN55 for a 55-gallon drum.
7: (Q) What should I do if my feeder isn’t working? (A) Check
the battery first by changing to a known good battery. If a
problem still exists, call Moultrie Customer Service at the
number below.
8: (Q) What type of battery should I use? (A) For best
performance, use a rechargeable 6-Volt, 5 Amp Moultrie brand
battery. If disposable batteries will be used in your unit,
EnergizerTM alkaline batteries are required for proper operation.
9: (Q) Can I get replacement parts for my feeder? (A) Yes, you
may purchase the following Moultrie replacement parts.
• 6V Rechargeable Battery .........................MFH-RB6
• 6V Battery Charger ..................................MFH-BC6
c a u t i o n: wear eye pr ot ec t i on
EVENING Feed Control Knob
To feed earlier in the day, rotate
the knob counter clockwise. The
default setting is fully clockwise.
Install a 6-Volt Alkaline (ex. EnergizerTM)
or Moultrie rechargeable battery by
attaching the Red Alligator Clip to the
positive terminal (+) and the Black
Alligator Clip to the negative (-) terminal.
Your Moultrie Pro-Line Directional Feeder Kit is Light Sensor Activated and will feed twice per
day, at dawn and again at dusk.
061604R 05 / MF HP60107