Mount-It! MI-7610 User manual

MICROPHONE BOOM ARM
MI-7610

Thank you for choosing Mount-It
23
Clamp Assembly
Boom Arm
Grommet Bolt
Grommet Adapter Grommet
Wing Nut
Use with products heavier than the rated weights indicated may result in instability causing possible injury.
Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.
Safety gear and proper tools must be used. This product should only be installed by professionals.
Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, contact Mount-It!
for a replacement.
Check that the product is secure and safe to use at regular intervals (at least every three months). A (x1) C (x1)
M6x100
B (x1) D (x1)
E (x1)
Mount-It!
1kg
(2.2lbs)
RATED
PACKAGE CONTENTS
Check carefully to make sure there are no missing or defective parts. Some hardware
provided may not be used.
CHOKING HAZARD. Package includes small parts.
Not for children under 3 years. Adult supervision is required.

5
4
1.Insert the Grommet adapter #C into the slot that the C-clamp was just removed from.
2.Place the Grommet Bolt B through the center hole on the base as pictured and place the assembled
piece over the grommet hole on your desktop.
The grommet bolt is compatible with desktops up to 2.36” thick. For stable installation, the Wing nut #D
and the circular plate must be adequately engaged with the desk and the Grommet bolt #B
3. Position the circular plate on the Grommet bolt #B as shown (circular plate was removed from the
clamp assembly in the previous step). Tighten the assembly by attaching the Grommet Wing Nut #D to
the bottom of Grommet Bolt #B and tighten until secure.
4. Attach the Boom Arm E into the top of the now installed base.
Grommet Installation Continued
To install in the clamp configuration attach Clamp Assembly A to the desk in the desired location and
insert the Boom Arm E into the top of the clamp as pictured.
Option 1: Clamp Installation
1.To install in the grommet configuration, use a Philips head screwdriver and remove the bolt and nut
from the top of the Clamp Assembly A.
2.Pull out the C shaped bracket from the base .
3.Using the screwdriver, remove the screw from the end of the bolt to detach the circular plate attached
to it.
Option 2: Grommet Installation
Step 1
A
10-60mm
E
A
10-60mm
D
C1
2
B
E

7
6
Universal Adapter Included
compatible with most microphones,
shock mounts and pop filters
Fit for 5/8" adapter and 3/8" adapter
Before installing your microphone be
sure to loosen the nut shown above to
leave a gap of approximately 2mm for
smooth installation
Final Adjustment
Step 2
2mm
-240°
0°
+45°
-90°
-20° +60°
CABLE
MANAGEMENT
for a neat and
clean look
360°
rotation
JOINT ADJUSTMENT
Adjust the microphone
boom arm position at
each joint. Loosen the
knob, adjust position
and tighten to lock in
the desired position.