MOX Luceo User manual

Luceo
Profile Parts
Aluminium LED Skirting Profile Installation Guide
Technical details
Material: Aluminum
Height: 97.2 mm
Width: 12.9 mm
Length: 2700 mm
Mox Profile Systems LED Profile Technology is an easy-to-install LED system that
Top LED Strip Channel
Bottom LED Strip Channel
Luceo Transparent PVC Strip
Cable Channel
Luceo Rear Profile
Luceo Front Profile
Luceo Front Profile

Luceo
Fixing to Wall
Aluminium LED Skirting Profile Installation Guide
Fixing with PP/96 type adhesive or with screws and plugs.
Remove the skirting board profiles (base and insert) from the package.
Where present, also remove any protection (protective and/or shrink-wrapped
film) added to protect the finish.
Measure the length required and cut the skirting board profiles (base and
insert) to this length using an appropriate tool.
Fixing to brick wall
Fix using suitable adhesives (such as PP/96)
Place the skirting board base profile, cut to the right length, in
position and fix it to the support with the adhesive, making sure that
the support is
free of dirt and perfectly clean. Press and hold evenly along the
length of the skirting board base profile for a few minutes to make
sure it bonds
correctly with the laying surface; any excess adhesive must be
removed so that it is not still visible on completion.
Screw-fixing
Place the skirting board base profile, cut to the right length, in
position and use a permanent marker to mark every 50 cm the exact
position of the holes on
the base profile, where holes should be drilled. Remove the base
profile and drill holes in the wall, in the positions that you marked
previously,
being careful to check the exact size of the plugs needed. Slot the
plugs into the holes drilled in the wall; reposition the profile correctly
and fix it
to the wall using the right type of screws, making sure that the
support surface is perfectly clean.
Apply plaster coating to the wall, being careful to protect the visible
part of the skirting board.
Fixing to plasterboard walls
Place the skirting board base profile, cut to length, in the correct
position; fix with suitable self-tapping screws to the plasterboard stud
frame
before assembling the plasterboard panels, making sure the area
where the profile is to be attached is perfectly clean.
Fixing insert profile
Before attaching the insert, thoroughly clean the area to which it will
be fixed.
Place the insert, cut to length, in the skirting board cavity, fixing it
with a thin layer of a suitable adhesive (such as PP/96) or using the
adhesive already
present on the insert.
Press and hold evenly along the length of the insert to make sure it
bonds correctly to the surface of the skirting board.
Any excess adhesive must be removed so that it doesn’t show on
completion.
50cm
H
W
Concrete
Wooden Wall
Ceramic
Plasterboard

Luceo
LED Strip Cutting & Extending
LED Strip Wiring Diagram
Aluminium LED Skirting Profile Installation Guide
Application of LED Strip
Apply the LED strips to the LED channels as indicated in the visual. Examine the following diagram to extend or join the LED strips.
For correct operation of the LED Strip, cut only from the
location indicated in the diagram.
To avoid disconnection between the LED Strip, solder only
at the location indicated in the sample drawing.
MOX
RGB
Controller