Mr. Black Tapex 2 User manual

Ah that magical sound of a magnetic tape echo. There’s nothing quite like it, except of course: the Tapex 2!
Thank you for acquiring one of the best tape echo pedals available today, made entirely by hand, with love and
care from Mr. Black, here in Portland, Oregon U.S.A.
The Tapex 2 captures the beauty and natural irregularity of a mechanical tape
echo with complimentary stereo outputs, two modes of operation, and modern
bonuses like tap-tempo, assignable expression pedal control and even the ability
to save and recall your favorite settings, all on the fly.
The left output features up to 808mS delay time, while the right output
compliments the left at exactly half of the delay time, creating a spacious and
dynamic soundscape complete with all the nuances imparted by the old-style
mechanical magnetic tape echo method of echo.
CHOICE mode replicates a tape echo in good running condition, with smooth
mechanicals and fresh tape, while DAMAGED I mode brings in the wear and tear
you would expect after a long life of rock n roll.
There are quite a lot of sounds and capabilities held within this wonderful
instrument and using the Tapex 2 is a snap.
For a mono setup, simply connect your instrument to the IN-L jack, and
your amplifier to the OUT-L jack. You can expand to true-stereo by simply
connecting a second amplifier to the OUT-R jack, no IN-R connection is required, but it is there if you need it.
see back for operation, configuration & technical specifications

Technical Specs:
Input Impedance: ~500kΩ
Output Impedance: ~2kΩ
Echo Time: 43mS - 808mS
Bypass: Buffered-bypass
Power Requirement: 9-18VDC (100mA)
Current Draw: <70mA
Tap Tempo Pedal Use:
Connect tap-tempo pedal to TAP/EXP. jack. Tap twice to set tempo.
Wiring Connections:
Tip - Normally open switched connection
Sleeve - Ground
Saving a setting:
Set controls and mode to desired setting & press the SAVE button once.
RECALL light will blink 3 times and remain lit while the controls are
aligned with the saved control knob settings.
Control Knobs:
LEVEL: Adjusts echo level
REPEATS: Adjusts regeneration/trail
TIME: Adjusts delay time
Input/Output Jacks:
IN-L: Left/Main Input
IN-R: Right/2nd Input
TAP/EXP: Tap/Expression
OUT-L: Left Output
OUT-R: Right Output
POWER: 9-18VDC input
*see polarity diagram
Recalling a saved setting:
Press the RECALL button once. All control settings and mode saved will
be activated. Press the RECALL button again to resume current knob
settings and previously active mode, if different than saved mode.
Changing modes:
Press the CHOICE/DAMAGED I button. The LEDs will display mode color.
Expression Pedal Use:
Connect expression pedal to TAP/EXP. jack, turn control(s) to be assigned
to expression pedal fully CW (EXP region). Wiring Connections:
Tip - Wiper
Ring - Positive Voltage
Sleeve - Ground
(10KΩ or greater)