Mueller PX9 User manual
INSTRUCTION MANUAL
PERSONAL
GROOMING KIT
Model: PX9
9 IN 1
TO REDUCE THE RISK OF ELECTRIC SHOCK:
- Do not reach for a product attached to a power cord that has fallen into the
water. Unplug immediately.
- The product, power cord, and the accessories connected to it are NOT
for immersion or use in the shower.
- Do not use an extension cord with this product.
- Do not place or store the product while plugged in, where it can fall into a
tub or sink. Do not place or drop the product or the power cord in water or
other liquid while plugged in.
- Always unplug this product from the electrical outlet immediately after
(re)charging.
- Unplug and remove the power supply cord from this product before clean-
ing.
IMPORTANT SAFETY INSTRUCTIONS
DANGER
When using an electric product, basic precautions should always be followed,
including the following: Read all instructions before using this product.
WARNING
TO REDUCE THE RISK OF BURNS, FIRE, ELECTRIC SHOCK, OR INJURY
TO PERSONS:
- Before connecting the power adapter to a power socket, make sure that
the voltage on its rating label corresponds to the voltage in the power
socket to which you wish to connect it.
- Close supervision is required when this product is used by, on, or near
children or persons with limited physical, sensory, or mental capabilities or
invalids.
- Use this product for its intended household use, as described in this
manual. Do not use attachments not recommended by Mueller.
- Never operate this product if it has a damaged power cord, if it is not work-
ing properly, after it has been dropped or damaged, or dropped into water
while plugged in. For assistance, contact Mueller support.
- Do not disconnect the power adapter from the power socket by pulling on
the power cord- this could damage the power adapter or the power socket.
Disconnect the power adapter from the power socket by pulling on the plug.
-Make sure that the power cord does not hang over the edge of a table and
that it is not touching a heated surface.
-The Hair clipper must be used only with the original power adapter that
came with it. To avoid a dangerous situation from arising, never use a differ-
ent power adapter.
-Never use the power adapter supplied with this Hair clipper for any other
purposes.
-Keep the power adapter and its power cord dry.
-Do not wind the power cord of the power adapter around the handle of the
Hair clipper.
-Do not connect and disconnect the power adapter cord to and from the
power socket with wet hands.
- Do not charge the shaver when the temperature is below 0°C (32°F) or
above 40°C (104°F).
-Do not charge the Hair clipper for longer than is necessary for it to charge
fully. Once it is charged, disconnect it from the power socket.
- Never put the product or the power cord in direct sunlight or store at a
temperature above 140°F (60°C).
-The Hair clipper is equipped with a built-in long-life battery that can only be
removed from the Hair clipper at a professional service center. Never
attempt to remove it from the Hair clipper yourself.
-Do not place the Hair clipper and its accessories near heaters, open fires,
or other sources of heat.
IMPORTANT
This shaver has a built-in rechargeable battery. Do not throw it into the
fire, apply heat, charge, use, or leave in a high-temperature environment.
-Do not charge, use or store the Hair clipper or leave it lying in a bathroom
or in locations where it could fall into a bath, washbasin, or other containers
filled with water.
- Do not clean the Hair clipper under a water tap, do not spray it with water
or any other liquid or submerge it in water or any other liquid.
-Before every use, check the cutting unit and comb attachments for
damage. Never use a Hair clipper with a damaged cutting unit or comb
attachment.
-The Hair clipper may heat up during use or when it is charged- this is com-
pletely normal.
-Keep the Hair clipper at a safe distance from the eyes.
-Always turn off the Hair clipper and disconnect it from the power socket
when not using it, when leaving it without supervision and before attaching,
removing or replacing comb attachments, and before cleaning, mainte-
nance or storage. Store the Hair clipper and its power adapter in a dry envi-
ronment.
-Keep the Hair clipper clean. Perform cleaning and maintenance according
to the instructions in chapter Cleaning and maintenance.
-Only use the cutting blade lubricating oil by following the instructions in
this user’s manual and store it out of children’s reach. Keep the oil at a safe
distance from the eyes and sources of heat.
-Do not perform any maintenance on the Hair clipper other than cleaning
the individual parts of the Hair clipper as described in chapter Cleaning and
maintenance.
-Do not use the Hair clipper if it has fallen on the floor, if it was submerged
in water, if it is not functioning correctly or if it is damaged in any other way.
-The Hair clipper and its power adapter must only be used in indoor areas.
Do not use it outdoors.
-Do not use the Hair clipper in rooms where aerosol sprays are used or
where oxygen is administered.
-To prevent a hazardous situation arising, do not repair the Hair clipper or
any of its accessories yourself or modify it in any way. For assistance,
contact Mueller support.
WARNING
INTRODUCTION
Thanks for purchasing the Mueller 9 in1 Personal Grooming Kit. Your
satisfaction is guaranteed. If you are not completely satisfied with our
9 in1 Personal Grooming Kit, and the results it brings, we insist that you
let us know. We’ll help you make the 9 in1 Personal Grooming Kit work
for you, or we’ll refund your money.
INTENDED USE
- This Hair clipper is intended for home use only and is designed for
cutting human hair and beard. The Hair clipper is not intended for com-
mercial purposes or for trimming animal fur.
- Do not use the Hair clipper on wet or just washed hair or on beard on
which a shaving foam or gel, etc. has been applied.
- Use the Hair clipper and the individual comb attachments by following
the instructions contained in this user’s manual.
- This Hair clipper is safe to use to cut children’s hair.
- Use only the original accessories supplied with this Hair clipper.
PARTS
Full-size
blade
Power
switch
Charging
indicator
Stand
Adaptor
Comb
Beard
trimmer
blade
Detail
trimmer
blade
Comb
3mm
Beard trimmer
comb 3mm
Beard trimmer
comb 7mm
Beard trimmer
comb 5mm
Comb
6mm
Comb
9mm
Cleaning brush
Lubricating oil
Comb
12mm
Comb attachments
3/6/9/12mm
(0.1/0.23/0.35/0.47”)
Beard trimmer
comb attachments
3/5/7mm
(0.1/0.2/0.27”)
1. Make sure that the Hair clipper is turned OFF before charging it.
2. Connect the power cord to the Hair clipper and put the power plug in any
120-240V AC outlet. The charge status indicator will glow RED when the
Hair clipper is being charged.
3. Regular charging takes approximately 8 hours. A fully charged Hair
clipper will run for about 50 minutes.
Recommendations for achieving the longest possible battery lifetime:
• Charge the Hair clipper at room temperature.
• Do not leave the Hair clipper connected to the electrical power source for
longer than it is necessary to charge it.
• Ideally, store the Hair clipper fully charged.
• If you do not use the Hair clipper for a long time, charge it at least once
every six months.
Using your Hair clipper for the first time requires a full charge.
Full charge means charging your product for 12 hours.
You should also perform a full charge after not using
the product for a long time (longer than three months).
USING YOUR HAIR CLIPPER FOR THE FIRST TIME
CHARGING
8HR
12HR
50
min
1. Inspect the clipper making sure that it is free from hair and dirt.
2. Make sure that the Hair clipper is free of oil between the cutting blade
teeth. Wipe off any excess oil and then turn the unit ON to distribute the oil
and to make sure it is running smoothly. This should be done after each
use.
3. Before cutting, always comb the hair so it is tangle-free and dry.
4. Seat the person whose hair you will be cutting in such a way that their
head is at the height of your chest.
5. Use a towel to cover the neck and shoulders to protect clothing from hair
clippings.
6. Switch the Hair clipper ON by pushing the Power switch upwards.
7. When you finish with the cutting, turn OFF the Hair clipper by pushing the
Power switch downwards.
OPERATING THE HAIR CLIPPER
- Cutting hair requires practice, so it is always better to leave the hair longer
for the first few haircuts until you become used to the length to which each
comb attachment cuts the hair.
- To ensure an even haircut, the flat part of the comb attachment must
constantly remain in contact with the scalp. Slowly move the Hair clipper
against the direction of hair growth.
- Regularly remove hair accumulating in the attachment. Before removing
the hair, turn OFF the Hair clipper.
NOTE: Do not use the clipper in the opposite direction as it may cause cuts.
CUTTING YOUR HAIR
USING THE PRODUCT
THE HAIR CLIPPER IS SUITABLE FOR CUTTING DRY OR LIGHTLY DAMPENED
HAIR OR BEARDS. DO NOT USE IT TO CUT HAIR THAT HAS JUST BEEN WASHED.
- Use the Beard trimmer blade to trim your beard.
- Trim the beard when it is dry without the use of shaving gels or foams.
- The Beard trimming combs allow you to trim your beard to different
lengths.
- When you trim for the first time, start with the longest comb to familiarize
yourself with the product.
- Trim the beard by slowly moving against the growth direction of the
beard, going from the bottom upwards.
- Always trim in the direction of the teeth of the Beard trimming comb,
making sure the flat part of the comb is in full contact with the skin for an
even trimming result.
- The Detail trimmer blade is suited for creating fine details on the
hair/beard.
BEARD TRIMMING
ATTACHING THE BLADE
Insert the bottom part of the blade
into the blade socket and snap the
blade in place.
Place your thumb under the teeth
of the blade and pull it upwards to
remove the blade.
REMOVING THE BLADE
ON
1. Switch OFF the Hair clipper.
2. Remove the attachment comb and the blade from the Hair clipper.
3. Use the cleaning brush to remove the hair clippings from the blade and
comb attachments.
4. Clean the blade with running water.
5. Wipe off any drops of water with a dry cloth.
6. After cleaning the blades, we recommend using a rubber alcohol to disin-
fect them. It keeps all blades hygienically clean and is effective against
bacteria and viruses.
ATTACHING A COMB
Hook the front edge of the comb
to the front teeth of the blade.
Then push the back of the comb
down until it snaps in place.
REMOVING A COMB
Push up the back of the comb until it
clicks o the clipper blade.
CLEANING AND MAINTENANCE
LUBRICATING THE BLADES
We recommend lubricating the blades after each cleaning to protect them
against corrosion. A special lubricating oil was provided with your product
for this purpose.
1. Switch OFF the Hair clipper.
2. After removing and cleaning the blade, apply two to three drops of oil
between the cutting teeth and smear evenly.
3. Wipe off excess oil using a clean, dry cloth.
4. Turn the appliance ON briefly (approx. 10 seconds) to ensure the oil film
is evenly distributed.
NOTE: When all the supplied oil has been used up, use an oil that does not
contain acids. For example, you can use some light machine oil such as
sewing machine oil. Do not use hair oil, grease, or any oil mixed with kero-
sene or any solvent, as the solvent will evaporate and leave the thick oil,
slowing down the blades.
DISPOSAL
The battery contains substances that may pollute the environment and, therefore, must
be disposed of properly. Contact your local town or city officials for battery disposal
information. You can also call 1-800-822-8837 or visit www.call2recycle.org for battery
drop-off locations.
Your product is designed and manufactured with high-quality materials and components,
which can be recycled and reused. For recycling information, please contact your local
waste management facilities.
ACCESSORIES
Replacement blades may be purchased at muellerdirect.com
1
YEAR This product is warranted to be free from defects in material and
workmanship under normal use and service for one year from the
date of the original purchase with the receipt. The manufacturer's
obligation shall be limited to repairing or replacing any part of the
product that is defective. Such warranty shall not apply to damag-
es resulting from accidents, abuse, or misuse.
If you are not happy with the product for any reason, please
your feedback or questions, and we will do our best to make
things right for you!
Your purchase comes with a 100%
satisfaction guarantee from Müeller
1-Year Limited Warranty
Technical specifications:
Model No.: PX9
Power source: 120-240V~ 50/60Hz
Motor voltage: 2.4V
Charging time: 8 hours
Running time: 50 minutes
This product is intended for household use only.
1714 Franklin St, Ste 102, Oakland, CA 94612
E-mail: [email protected]
Web: www.muellerdirect.com
Müeller USA
Table of contents
