Muller 2204A User manual

It shall apply from: 03-02-2016 r.
ASSEMBLY INSTRUCTION
OF PEDAL-POWERED MERRY-GO-ROUND
2204A Pedal-Powered Duck Merry-Go-Round
2204B Cycle Merry-Go-Round

ASSEMBLY INSTRUCTION
Product name: 2204A, 2204B Pedal-Powered Merry-Go-Round
Page 2of 4
TABELE OF CONTENTS
INTRODUCTION ....................................................................................................................................... 2
STAGE 1 –preparatory work ................................................................................................................... 3
STAGE 2 –assembly of the construction................................................................................................. 3
1. List of components ...................................................................................................................... 3
2. Assembly scheme ........................................................................................................................ 4
INTRODUCTION
2204A - Max. free fall height: 0,46 m
2204B - Max. free fall height: 0,55 m
Depth of foundation: 0,38 m
Impact area: Ø6,24 m
230
380
2042
O6240
Impact area

ASSEMBLY INSTRUCTION
Product name: 2204A, 2204B Pedal-Powered Merry-Go-Round
Page 3of 4
STAGE 1 –preparatory work
Secure the assembly site to keep others at a distance
Set the construction in the selected location while maintaining required impact area
Mark approximately points of contact between stanchions and the ground.
Foundations positions:
O1809
1279
6240
1279
WARNING !
All installation activities shall be performed in accordance with health and safety standards
A foundation setup tolerance is ± 50 mm.
STAGE 2 –assembly of the construction
1. List of components
No
Name of component
Dimension
Qty.
1
Pedal-powered merry-go-round
1
2
Steel feet
4
3
Concrete foundation
O-320-4D
4
4
Hexagon head screw
M10x25
16
5
Carriage bolt
M10x35
4
6
Washer
Ø20xØ10,5x2
20
7
Nut
M10
4
8
Screw cap
M10
4
9
Screw cover
M10
4

ASSEMBLY INSTRUCTION
Product name: 2204A, 2204B Pedal-Powered Merry-Go-Round
Page 4of 4
2. Assembly scheme
Determine foundation setup
Turf (if any) shall be removed and set aside
Excavate holes for foundations with a appropriate depth
Put the foundations into the holes
Screw the feet to the track
A
A ( 1 : 5 )
1
9
7
6
8
2
1
2
2
1
1
Screw the device to the foundations
B
B ( 1:10 )
6
4
5
2
3
3
1
Level the construction and set its vertical alignment. Check if the basic level mark coincides
with level of the ground.
Remove the slacks in joints
Fill the holes with soil, compact it and level it with turf (if any) to the level of the ground
Put the statutory plate