MyBinding Keencut Foster User manual
ASSEMBLY
INSTRUCTIONS
GENERAL PURPOSE CUTTER
& STAND
WITH WASTE CATCHER
4x
a4x c
bd2x
2x 2x
2x
2x
f
h
e
4x
j
4mm
1x
You should have
1. Slide the adjustable foot brackets (A) into the ends of the foot extrusion (B)
and tighten using a crosshead screwdriver.
g2x
1a
b
1x
l
m1x
1x
k
2. Remove the two screws from the bottom end of each leg extrusion (C) using
a screwdriver. Fix each foot extrusion (B) to the leg using the two screws,
passing them first through the reinforcing plate (D).
NOTE: Check the foot (B) is positioned correctly on the leg (C) before inserting
the screws. The third hole is only used as an indicator and not for fixing.
TOP
2x
2
c
c
bd
✗
✓
2x
2x
4mm
3. Remove two screws from each end of the cross brace (E) using the 4mm Allen
key. Using the long end of the Allen key to offer the screw to the hole fix a
leg to each end of the cross brace.
4. Remove two screws from the top end of each leg and fix the two support trays
(F) ensuring the arrow shaped holes are pointing to the middle of the stand.
3
4
c
f
c
e
e
2x
h
f
j
===
5. Fix the waste catcher brackets (G) to the outside edges of the trays using a
screwdriver and screws (H).
When the stand is finished and the cutter fitted the waste catcher bag (K) can be
placed on the brackets as shown.
6. Place the level adjusters (J) in the top of the cross brace, they may need to be
tapped into position with a mallet or small hammer and piece of wood.
5
6
k
g
7. Before fitting the cutter to the stand place the cutter on a table top and attach
the Squaring Arm (L) using the two screws and nuts provided. When
tightening the screws ensure the arm is set at right angles to the cutting edge
using a piece of paper or card as shown.
8. Fix the scale by placing a piece of card on the cutter and up to the squaring
arm, slide the measuring stop to the back corner and fasten it. Insert a blade
(see user instructions) and cut the card by depressing the cutting head and
drawing it across the card smoothly. Measure the cut dimension of the card
and stick the scale (M) in position such that it reads the measured dimension
(X) at the stop.
7
8X
X
l
2x
✗
✗
✓
9. Ensure that the two brackets within each tray are pushed towards each other
and the screws loosened.
Place the cutting machine onto the trays and locate the ribs on the underside into
the notches in the raised edges of the trays.
Pull the brackets and screws apart to lock the cutter to the stand and tighten the
screws.
10. For the cutter the grip the material being cut , and cut accurately the base of
the cutter must be set flat. Using the level adjuster (J) screw it up or down to
support the base accordingly.
9
10
j
e
f
Add the waste catcher bag and your cutter is ready for use.
Other MyBinding Rack & Stand manuals
