Spinning 7817 User manual

DUAL WATER BOTTLE
HOLDER MOUNT
7817
MEDIUM
LONG
SINGLE WATER BOTTLE
HOLDER MOUNT
7817 BALL MT
DELUXE TABLET HOLDER
WHAT’S INSIDE
OR
6
4
4
7817 and 7817 BALL MT
ATTACH THE MOUNT TO THE BARS 1
POSITION THE MOUNT ON THE
BARS AS SHOWN.
1
1
PLACE WASHERS UNDER
EACH SCREW AND USE
A PHILLIPS SCREWDRIVER
TO SECURE.
2
2
PLACE THE WASHER AND
THEN SECURE THE BOLT BY
TIGHTENING THE NUT TO THE
UNDERSIDE OF THE TAB.
PUSH THE BOLT THROUGH
THE BALL AND THREAD IT
ONTO THE CENTER WATER
BOTTLE TAB. YOU MAY NEED
TO REMOVE THE RUBBER
COATING AROUND THE
THREADS. USE A 4mm ALLEN
WRENCH TO TIGHTEN THE
HEX BOLT.
OR
6

ATTACH THE GRIP TABS 2
SLIDE THE TABS IN FROM THE SIDE. USE THE BEST
COMBINATION OF MEDIUM AND LONG TABS
TO FIT YOUR TABLET.
ASSEMBLE THE ARM AND TABLET HOLDER 3
PUSH IN AND SLIDE TO
ENGAGE SNAP LOCK
PUSH IN TAB TO RELEASE
LONG LEVER IS
USED ON THE
BIKE MOUNT BALL
4
SPINNING® HEADQUARTERS
SPINNING®
2111 Narcissus Court • Venice, CA 90291 • USA
TEL 800 847 SPIN (7746) or 310 823 7008 FAX [phone]
EUROPE
Scheldeweg 3 • 3144 ES Maassluis • The Netherlands
TEL [phone] • FAX [phone]
Safety Precautions
Install the tablet mount securely. Do not adjust the tablet or tablet mount while pedaling. Remove
the tablet before moving your indoor cycle and do not place direct force on the tablet mount.
Mad Dogg Athletics, Inc. is not responsible for any injuries or damages caused to any person or
item during the installation or use of this tablet mount.
©2019 Mad Dogg Athletics, Inc. All rights reserved. Spin®, Spinner®, Spinning®, SPINPower® and the
Spinning® Logo are registered trademarks that are owned by Mad Dogg Athletics, Inc.
PUSH DOWN AND BACK TO SECURE
ATTACH YOUR TABLET AND ADJUST ANGLE 4
GO RIDE!
5
ADJUST ANGLE AS
DESIRED AND TIGHTEN
KNOBS TO SECURE
1
2
3