Mylaps X2 BASELINK User manual

QUICK START GUIDESUPPORT
BASELINK
MYLAPS EMEA O ce
Haarlem, The Netherlands
Tel: [phone]
Email: [e-mail]
MYLAPS Americas O ce
Atlanta, USA
Tel: [phone]
Email: [e-mail]
MYLAPS Japan O ce
Tokyo, Japan
Tel: [phone]
Email: [e-mail]
MYLAPS APAC O ce
Sydney, Australia
Tel: [phone]
Email: info.asia.paci [e-mail]
MYLAPS Asia O ce
Selangor, Malaysia
Tel: [phone]
Email: [e-mail]
In case you encounter any issues,
please contact your sales o ces:
version 1.0 | art. #1702030906

BASELINK
WHAT IS IN THE BOX?
2
Ethernet Cable 25m
X2 BaseLink POE Injector
Power Cable
Cable Strain Relief 1x 1x
Ethernet Cable 2m
Required, not included
X2 Decoder X2 Server Orbits 5.3 or higher

QUICK START GUIDE
BASELINK
1INSTALLING
An obstacle free line of sight is required.
The range is 500 - 1000 meters.
Obstacle can cause interference including
trees, buildings, dunes, water and steel
objects.
Pipe diameter is Ø 42.4 mm (1.74 inch/size 7).
Use a 8 mm allen wrench to mount BaseLink
on pipe.
3
Check BaseLink LED Lights
B
Flashing Green
BaseLink Idle Mode
X2 Server Connected in Master Mode
Flashing Blue
BaseLink Startup Mode
Flashing Red
BaseLink Idle Mode
X2 Server Disconnected in Master Mode
Solid Green
BaseLink Broadcast Mode
X2 Server Connected in Master Mode
Solid Blue
BaseLink Reset Mode
Press Reset Button 4 sec
Solid Red
BaseLink Diagnostics Mode
X2 Server Connected in Master Mode
Loop*
Ethernet
Cable*
OUT -> BaseLink
IN -> X2 Server
Keep Dry
Timing Software*
X2 Server*
Use the Cable Strain
Relief to give the
Ethernet Cable
some slack
LED Status Indicator
X2 Decoder*
X2 BaseLink
POE
Injector
Power Cable
Ethernet
Cable*
Coax*
Ethernet
Cable*
Ethernet
Cable
25m
Ethernet
Cable
2m
Installation Diagram
A
* Not included

QUICK START GUIDE
BASELINK
2CONNECTING
Connect the X2 BaseLink to the X2 Server.
Then enable the Onboard Feed to use the
Baselink to send messages to the Racers.
Use Orbits 5.3 or higher (or other supported
3rd party software).
AConnect X2 server to the Timing Software
BConnect to the X2 BaseLink*
* If you can’t nd the X2 BaseLink check the “not con gured” section
Go to the Distribution tab (green = on, red = o )
CEnabling the Onboard Feed
Click the Onboard Feed section to open the Settings window
D
Open the Onboard Feed Setting
E Check the Enable Onboard Feed Checkbox F Check Onboard Feed and online App Feed status
4