Naomi Home Canopy Cedar Sandbox User manual

Assembly Instructions
Product Dimensions:
46.5” L x 46.5” W x 57” H
Please take a moment to read through the entire instruction booklet before assembly to
familiarize yourself with this product. Once you feel ready to start, follow the instructions
step by step and this should make this process as easy as we could make it for you.
If you need help or have damaged or missing parts, contact customer service at
www.NaomiHome.com.
Page 1 of 8
NAOMI
Canopy Cedar Sandbox
KIDS
©
2017 Naomi Home Inc. - All Rights Reserved.

Tools Required
Phillips Screwdriver
(Medium)
Page 2 of 8
ADULT ASSEMBLY REQUIRED
CHOKING HAZARD
•This product includes small parts, sharp points and sharp edges in its unassembled
state. Keep unassembled parts away from children under 3 years of age, & animals.
•If used improperly, your sandbox canopy may be pulled over or fall, creating risk of injury
or damage. Children should not be permitted to climb or pull on the sandbox or canopy.
USE AND MAINTENANCE
•Use on level surfaces only
•Because this product needs assembly, it is prone to working itself loose from time to
time depending on the use. Please take the time to check that all connections are still
tight and working properly for safety.
•Only clean using a damp cloth and mild detergent, do not use bleach or abrasive
cleaners.
PARENTAL SUPERVISION IS REQUIRED
•This Naomi Home Kids product is intended for child use age 3+.
•Parents or Guardians should supervise use under the intended age specifically
regarding children that may have access to it and might climb on the unit.
ASSEMBLY RECOMMENDATIONS
•Check you have all the components and tools listed on page 2 and 3.
•Do not stand or put weight on this product during assembly, this could cause damage.
•Remove all hardware from the plastic bags and separate them into their groups.
•Assemble the item as close to its final position (in the same room) as possible.
•Assemble on a soft level surface to avoid damaging the unit or your floor.
•Make sure you have enough space to layout the parts before starting.
•Parts of the assembly may be easier with 2 people.
•Dispose of all packaging carefully and responsibly.
•Do not use this item if any components are missing or damaged.
•We do not recommend the use of power drill/drivers for inserting screws, as this could
damage the unit. Only use hand screwdrivers.
WARNING CAUTION

Box Side
x 2
1
COMPONENT PARTS
Please check that you have all the parts listed below
Bench Box Side
x 2
Bench Back Rest A
x 2
Bench Back Rest B
Back Rest Block
x 2
Bench Seat
Canopy Support A Canopy Support B - x 4
Screw 3.5 x 45mm Screw 3.0 x 30mm
x 2 x 2 x 2 x 6
Page 3 of 8
Screw 3.0 x 12mm
x 24
ASSEMBLY HARDWARE
12 3 4
5
E
Canopy Frame Ends Canopy Cross Bar
With Velcro
678
910 11 12
x 4
Base liner
x 1
Canopy
x 1
BA C D
Screw 3.0 x 38mm Screw 3.0 x 18mm
x 8 x 20 x 32 x 16
13
Canopy Cross Bar
Without Velcro x 1

ASSEMBLY INSTRUCTIONS
2
1
Place (11) down on
ground where you
intend to install
sandbox. Do not
Tear or Puncture
liner. Select Part 1,
2, and C Screws
(12). With wood
block interior on 1,
ax 2 to 1 with C
screws. Repeat
other 3 corners.
Select part 5, C
Screws (8). Insert
B screw through
part 1 and ax 5
to part 1. Repeat
for other 7 screws.
Page 4 of 8
C
C
C
C
1
1
2
2
C
C
C
C
5
5
11

ASSEMBLY INSTRUCTIONS
4
3
Select part 3, 4, and
Screws E (12). Conrm
part 4 is facing up and
the widest support at
the ends is up. Part 3
the supports are
down and handle
curve toward part 4.
Insert (3) E screws
through hinge holes
and ax 3 to the
hinge connected to
part 4.
Select Screws E
(12). Turn over
assembly of 3 and
4 so the longest
support is facing
up. With the
handle toward the
center of the
sandbox place the
assembly on the
sandbox. Ax the
cover assembly
door/bench too
the sandbox with
(3) Screws E
through the hinge
holes. Repeat 3
additional hinges.
Page 5 of 8
E
3
3
4
4
x 12
x 12
E

ASSEMBLY INSTRUCTIONS
6
5
Select part 9, 10, D
screws (4). Align 9 and
10 and insert 4 screws
into holes and tighten.
Repeat for other 3
9&10 assemblies.
Select A Screws (8).
Using 2 A Screws,
select one canopy
support with 9 UP and
ax to the tabs on
part 1 of the sandbox.
Repeat for the
addtional 3 canopy
supports.
Select part 6 (2), 7
(2),13(1) B Screws (10).
Locate 13 (1) without
velcro and rest 7 (2) on
center tab of part 6 (1).
Using (2) B Screws ax
part 13 to the top
center holes of part 6.
Using 7 (1) (with velcro
up), ax with (2) B
screws at one end of 6
using the vertical screw
holes. Repeat 7 (2), and
(2) B screws at other
end of 6 (1). Repeat for
part 6 (2) on the oppos-
ing end of the assembly.
Page 6 of 8
B
F
F
D
D
A
A
A
A
9
10
D
D
D
B
B
B
B
B
7
13
7
6
6

ASSEMBLY INSTRUCTIONS
7
2 man lift. Select B
Screws (8). Lift and hold
canopy frame assembly
and mount the frame
assembly to the canopy
pole supports with the
pole on the interior of
the canopy frame.
Mount one corner of the
frame assembly with the
horizontal holes and 2 B
Screws. Repeat for the
support diagonal from
the rst. Repeat for
other 2 supports.
Page 7 of 8
Raise the Benches
upright. Select part
12. Mount the
canopy to the
velcro strips so the
canopy overhang is
above the bench
seat. Select part 8,
C Screws (12).
Mount block 8
below bench
backrest support
with (2) C
Screws.
Repeat for
5 other supports.
Recommend Fill
with (5 to 6) 50 lb
bags of play sand
(not included).
8
D
B
B
B
B
8
C
12

ASSEMBLY COMPLETE
Page 8 of 8
www.NaomiHome.com
MADE IN CHINA
Product Packaging Information
Model #: 40401
Color: Cedar
Shipment Ref. #: 03162017
Date: 5/10/2017
________________________________
__________________________________
_________________________
__________________________________
CONGRATULATIONS, YOUR NAOMI HOME KIDS
CANOPY SAND BOX IS COMPLETE!
NAOMI
KIDS