9. Installation
1. Turn the dog over and find the opening at the bottom (on the tummy).
2. Open the opening to make the switch visible.
3. You can now operate the switch.
a. When you slide the switch to 'OFF', the dog is completely out. It doesn't move or
make a sound. On this position the dog stands when you take it out of the package.
This mode saves battery, in if you don't use the dog for a few days.
b. When you slide the switch to 'MUTE', the dog is silent. All the other movements will
continue.
c. When you slide the switch to 'ON', the dog is completely turned on. He can move
and make noise.
10. Maintenance
-If dirt comes on the dog, remove it immediately.
-Do not use cleaning agents and/or stain removable. Use a damp cloth to remove dirt.
-The collar is removable and can be washed in the same way as the dog's fur.
-Never submerge the dog.
11. Replacing batteries
1. Open the opening under the dog (on his belly).
2. Open the hole by turning out the screws.
3. Remove the old batteries
4. Replace it with 4 new 1.5-VOLT C size akaline batteries.
5. Put the lid back on by tightening the screws again. Close the Velcro.
6. To see if the batteries are working, check that the switch is on 'ON' or 'MUTE'.