Fisher-Price N1418 User manual

Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “C” batteries (included) for operation.
Adult assembly is required for battery replacement.
Tool required for battery replacement: Phillips
screwdriver (not included).
www.fisher-price.com
N1418

Assembled Parts
Base
Treetop
Tree Trunk
2 Hedges
Tree Branch
2

Assembly
• Lift the arch on the base and “Snap” it
into the base.
Note: The arch is connected to the base
by an electrical wire. Make sure this wire
retracts into the arch before snapping into
the base.
1
2
1
1
• “Snap” the treetop to the tree trunk and
then into base.
Note: The treetop only fits onto the tree
trunk one way. If it does not seem to fit,
turn it around and try again.
• “Snap” the tree trunk into the base.
1
3
• “Snap” the hedges into the slots in
the base.
Note: If a hedge does not seem to fit into a
slot, try the other slot.
1
4
• Insert the tree branch into the arch and
the base.
• Push down on the tree branch to “snap”
it in place.
3
Arch
Base
Treetop
Tree Trunk
Hedges Tree Branch

Hint: For best performance, we recommend
that you replace batteries that came with
this toy with three, new "C" (LR14)
alkaline batteries.
• Locate the battery compartment on the
base of the toy.
• Loosen the screws in the battery
compartment door with a
Phillips screwdriver.
• Remove the battery compartment door.
Remove exhausted batteries and throw
them away.
• Insert three “C” (LR14) alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment door
and tighten the screws.
• If this toy begins to operate erratically,
you may need to reset the electronics.
Slide the power/volume switch off and
then back on.
• When sounds become faint or stop, it’s
time for an adult to change the batteries!
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn
injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of product
in a fire. The batteries inside may explode
or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
4
Battery
Replacement
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
Battery Safety
Information
1.5V x 3
"C" (LR14)

5
Rollin’ Around the Zoo
• Slide the power/volume switch on the arch to on with low volume , on with high
volume or off .
• Press the button on the base or ramp to hear fun songs.
Hint: Place the animals on the base and ramp and watch them roll around the zoo.
• Press the button on the arch for animal sounds and tunes.
Press
Press

Care
• Wipe the toy with a clean cloth dampened
with a mild soap and water solution.
Do not immerse this toy.
• This toy has no consumer serviceable
parts. Do not take this toy apart.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. N1418pr-0920
© 2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
FCC Statement (United States Only)
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/
TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user's authority to operate the equipment.
This device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
Consumer Information