NETGEAR ProSafe AFT200 User manual

Installation Guide Removing an AFT200 Fan Tray
Note: The AFT200 has a hot swap capability. It is not necessary to remove the AC
power when removing the AFT200 module.
To remove the AFT200 module, follow these steps:
1. Loosen the two captive screws on the fan tray.
2. Remove the fan tray from the fan tray slot by pulling on the captive screws.
Installing an AFT200 Fan Tray
To install an AFT200 fan tray, follow these steps:
WARNING!! When inserting a fan trayinto the switches, do not use unnecessary
force. Doing so can damage the connectors on the rear of the fan tray and on the
midplane.
1. Insert the new fan tray module into the fan tray module slot, and gently push
the module into the slot.
2. Align the two captive screws with the screw holes in the switch’s back panel.
3. Using a screwdriver, gently tighten the captive screws.
Specifications
Specifications
Dimensions (HxWxD) 1.60" x 4.22" x 2.34"
(40.60 x 107.29 x 59.55mm)
Weight 0.34lb(155 g)
Operating Temperature 32 to 122 ºF (0 to 50 ºC)
Storage Temperature -49 to 185 ºF (-45 to 85 ºC)
Operative relative humidity 10 to 90% and non condensing
MTBF 676058 Hours (~77 Years) at 25 ºC
85680 Hours (~10 Years) at 55 ºC
ProSafe®Auxiliary Fan Tray AFT200
The ProSafe® Auxiliary Fan Tray AFT200 provides a replaceable fan tray for
XSM7224S 10Gigabit Switch. If AFT200 of the switch fails to work , it is easy to
replace the failed one with a new fan tray. Two fan tray slots are provided by
XSM7224S 10Gigabit Switch.
AFT200_IG_2Nov10.fm Page 1 Friday, November 12, 2010 10:39 AM

November 2010
This symbol was placed in accordance with the European Union Directive 2002/96 on the Waste
Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the European Union,
this product should be treated and recycled in accordance with the laws of your jurisdiction
implementing the WEEE Directive.
©2010 by NETGEAR, Inc. All rights reserved. NETGEAR and the NETGEAR logo are registered trademarks of
NETGEAR, Inc. in the United States and/or other countries. Other brand and product names are trademarks or
registered trademarks of their respective holders. Information is subject to change without notice.
Technical Support
Thank you for selecting NETGEAR products.
After installing your device, locate the serial number on the label of your product and
use it to register your product at http://www.NETGEAR.com/register. Registration is
required before you can use our telephone support service. Registration via our
website is strongly recommended.
Go to http://kbserver.netgear.com for product updates and support information.
For complete DoC please visit the NETGEAR EU Declarations of Conformity
website at: http://kb.netgear.com/app/answers/detail/a_id/11621/
AFT200_IG_2Nov10.fm Page 2 Friday, November 12, 2010 10:39 AM