Nexo MSUB12-I User manual
PAGE 1 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
MSUB12-I
DP5300/Rev01 - DI
Installation kit for MSUB12-I
Contents:
X1
X1
X2
X1
X4
X4
PAGE 2 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
Rigging
Place MSUB12 on the top of a second MSUB18.
Insert 4 pins (2 on both sides).
Secure with the provided plats and the screws.
How to connect a second cable?
Remove the driver.
Wire the provided connector WAGO 4pt.
Plug it to the free connector.
Pass the cable through the cable-gland.
Tight the cable-gland.
Close MSUB12.
PAGE 3 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
Setting
MSUB12-I is packaged with the connection plate on the back. You can place a connection plate on the front.
Remove the connection plate with the cable glands. Place the
provided plate.
Remove the cable glands.
Assemble the cable glands on the front plate
Place the front plate on the grille. Pass the cable before closing
the front grille. The cable must pass through the lower left vent.
Table of contents
Other Nexo Rack & Stand manuals
