Nexo N200 User manual

N200 4X4 Power Rack

All nuts and bolts use a 17mm socket or wrench.
PARTS CHECK
4x Uprights
1
1
2x Lower Crossbeams
2
2
2x Upper Crossbeams
3
3
1x Rear Crossbeam
4
4
1x Regular Pull-up Bar
5
2x Metal Brackets
7
1x Fat Pull-up Bar
6
6
16x Upright Brackets
8
8
4x L Brackets
9
9
4x Rubber Feet
10
10
34x Regular Bolt Sets
8x Long Bolt Sets
11
11
5
7

STEP 1
Assemble the base of the rack using 2x Lower Crossbeams, 1x Rear Crossbeam,
4x L Brackets, 8x Upright Brackets, 4x Rubber Feet, and 18x Regular Bolt Sets.
Lower Crossbeams
Upright Brackets
Rear Crossbeam
L Brackets
Rubber Feet
Rubber Feet

STEP 2
Assemble 4x Uprights to the base of the rack using 8x Regular Bolt Sets. There is no top
or bottom, just make sure the 1inch holes are oriented like the picture.
NOTE: Remove the end caps from all of the uprights. You will
use four of these in a later step. A flat head screwdriver will work.

STEP 3
Assemble the top of the rack using 2x Upper Crossbeams, 1x Regular Pullup Bar, 1x Fat
Pullup Bar, 8x Upright Brackets, and 8x Long Bolt Sets.
Regular Pullup Bar
Upright Brackets
Upright Brackets
Upper Crossbeams
Fat Pullup Bar
NOTE: You can place four of the upright endcaps into the upper crossbeams

STEP 4
With a friend, install top of the rack onto the Uprights using 8x Regular Bolt Sets. One
person should hold the top in place while the other goes around to insert bolts.
Be sure to put your preferred pull-up bar toward the front of the rack.

STEP 5
Now you may tighten all the bolts up, it will be easiest with a power drill
as we include locking nuts with every bolt set. If you have any questions at all
please don’t hesitate to call us at 904.747.0789 or email [email protected]