Novitool Pun M NDX 114 User manual

–1–
Pun M™NDX Mobile Finger Punch
Rack and Rotation Guide Upgrade Kit Instructions
General Information
Pun M NDX 114: Item Code 104635
Pun M NDX 200: Item Code 104636
ac and otation Guide Upgrade it
Step 3. To remove rack, loosen and remove
four fasteners on belt support plate.
Discard fasteners.
Revision 1: has counterbored holes for rack
fasteners.
Revision 2: has countersunk holes for rack
fasteners.
Note: both styles of fasteners are included in
repair kit for replacement.
Step 6. Loosen, but don’t remove, ve
frame shoulder fasteners on one side
of punch.
Step 7. Remove three bottom plate
mounting fasteners on each side of punch.
Step 8. Remove bottom plate assembly,
set aside.
Step 4. To install new rack, place belt support
plate on top of rack, aligning fastener holes.
NOTE: If available, place a drop of low strength
threadlocker on the beginning thread of each
fastener prior to placing in hole.
Secure belt support plate to rack using four
new fasteners provided.
Step 5. Lock crank handle in the up
position and lay punch on its back.
Step 2. Remove belt support plate by
removing four fasteners on corners of
plate. Save fasteners for reuse.
Tools Needed:
4mm Hex Key
3mm Hex Key (some models)
T20 Torx Wrench
Step 1. Remove punch pad by
removing two fasteners at front
corners. Save fasteners for reuse.
Rev. 1 Rev. 2

–2–
Rack and Rotation Guide Upgrade Kit (cont.)
Step 9. Remove two rotation guide
mounting fasteners.
Step 10. Remove rotation guide. Step 11. Place new rotation guide into
belt support guide.
Step 12a. Align mounting holes of rotation guide.
NOTE: If available, place a drop of low strength threadlocker on
the beginning thread of each fastener prior to placing in hole.
Step 12b. Secure with two rotation guide mounting fasteners.
Step 13. Secure the bottom plate
by screwing in the three fasteners
on each side of punch.
Step 14. Set Pun M NDX
back upright.
Step 15. Insert refurbished belt support
plate assembly back onto the rotation
guide. Secure with four fasteners.
Step 17. Test by punching a belt sample.Step 16. Reinstall punch pad by
securing two fasteners at front
corners of pad.
Detail of new and old
rotation guide
2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 • USA
Tel: [phone] • Fax: [phone] • E-mail: info@flexco.com
Visit www.flexco.com for other Flexco locations and products.
©2022 Flexible Steel Lacing Company. 08/05/22. For reorder: 104029