nusantara TEAK RomanArch Hammock User manual

!
!
"#$%&!'()*!+%$$#),!-.%&/!'001$234!5&0.(6).7#&0!
!
89 :;:!<=>?-!!!!!!!!!!!!!@A!:41!<#3.0B!A!C%0*1(0B!A!D6.0E!
•Fix$the$eye$bolts$to$each$wooden$segment$
that$has$a$center$hole$where$there$is$a$
logo$cap.!
•Use$a$washer$on$the$front$and$rear$end$of$
the$bolt.$The$rear$washer$fits$into$the$
countersunk$hole.!
•These$will$be$the$center$segments!
!
!
!
!
A9 F'G5DH!?+:!'"I+! ! ! ! !! @J!>#&K!<#3.0B!L!C%0*1(0B!L!D6.0E!
!
•Align$the$2$base$segments$side$by$
side,$leaving$enough$space$for$the$
center$segments$in$between!
•Place$a$center$segment$in$between$
the$ base$ segments$ and$ align$ the$
side$holes$
•Ensure$that$the$countersunk$holes$
are$ on$ the$ outside$ to$ fit$ the$
washer$and$nuts$
•Place$a$nut$and$washer$on$one$end$
of$ the$ 4$ long$ bolts,$ and$ pass$ the$
long$ bolt$ through$ the$ side$ of$ all$
three$segments$
•Place$ a$ washer$ and$ nut$ on$ the$
other$ end$ of$ the$ bolt,$ and$ repeat$
this$step$with$the$remaining$holes.$
•Once$ all$ 4$ bolts$ and$ nuts$ are$
secured,$ tighten$ all$ nuts$ on$ the$
bolts$with$a$13mm$socket.$
$
$
$
!
!

M9 N==?!-:HF:D?-! ! ! ! !!!!!!!@J!N7O1/!+1%/!<#3.0B!L!C%0*1(0B!J!D6.0E!
!
•Place$ one$ foot$ segment$
underneath$ the$ base$ aligning$ the$
countersunk$holes$on$the$base$with$
the$holes$on$the$legs!
•Ensure$that$the$open$recess$on$the$
legs$is$facing$the$center$of$the$arch!
•Drop$ the$ fixed$ head$ bolts$ into$ the$
countersunk$hole$on$the$outer$base$
segments$ with$ a$ washer,$ and$ pass$
the$bolt$through$the$feet$segments.!
•Fasten$ a$ nut$ and$ washer$ on$ the$
bolt$underneath,$which$will$now$be$
protruding$ from$ the$ countersunk$
hole$ on$ the$ bottom$ of$ the$ leg$
segment!
•Repeat$this$step$ for$ the$ other$ foot$
segment,$ and$ secure$ the$ nuts$ to$
the$bolts!
!
J9 I=DN5"F!'>>!DP?-!'":!-:IP">:;!N'-?:D:Q!C5?+!'!8M$$!-=IG:?!<:N=":!P-:R!
!
S9 +'DH!?+:!Q":'FC:'T:"!+'FF=IG!! ! !!!!!!!!!!!!!!!!!!!!!!@A!I*%7&0B!J!U67),V!I37W0E!
!!
•Attach$the$quick$clips$to$each$chain,$and$one$clip$to$the$eye$bolts$on$the$center$segment$
•Fasten$the$other$quick$clip$to$one$end$of$the$hammock$rings,$and$repeat$on$the$opposite$end.$$
•Adjust$the$tension$by$adjusting$the$length$of$the$chain.$$
$