Oltens Bateria Assembly instructions

Bath shower mixer tap - fitting guide

Set of screws
Screw cap
Lever
Cover
Bonnet nut
Ceramic cartridge
Tap body
Shower diverter
Aerator
Outlet nozzle
Seal
Seal
Screws
Nuts
Seal
Rosette
Offset connector
No. Description Quantity
Note!
Accessories may change without affecting their function. The presented manufacturing drawings are for
illustration purpose only. The size and shape of the tap depends on the selected tap model.
Check the parts needed for the installation against the list
Installation procedure
Do not disassemble the body of the tap, as it had been assembled, installed and checked before it was
released by the manufacturer.
To avoid damaging the tap, prior to installation the piping system should be flushed to remove any
debris, such as sand, limescale and sludge.
After the installation, please ensure that all connections are tight and there are no leaks.

1. Screw in offset connectors (18) to water feed sections
ending with female thread G1/2, sealing the connection
with an appropriate amount of teflon tape or thread.
After the installation, the axes of openings in the offset
connectors (from the tap side) must be at the same
height, their face surfaces at the same distance from the
wall, and the spacing of the openings equal to the
distance between axes of connection nuts of the tap
body.
Water feed connections must be installed so that cold
water is fed to the right side of the tap and hot water to
the left side (looking from the front of the tap) and so that
axes of connections are perpendicular to the wall and in
parallel to each other.
2. Screw or put rosettes onto the offset connec-
tors.
Place seals (16) in connection nuts (15) and screw
them on the offset connectors of the tap (18).
Next, set them from the bottom of the tap body
with two Allen head screws.
After installation, check connections to ensure
there are no leaks
Note! The drawings are for illustration and instruction purpose only.
The appearance of the tap may be different from that seen in the drawings

Technical information
Maximum pressure 1 MPa
Recommended pressure 0,1 - 0,5 MPa
Maximum temperature of hot water 90°C
Recommended temperature of hot water 65°C
Check whether the installation of hot and cold water was done correctly.
Operation
To start the water flow and fluently adjust its rate, turn the handle vertically upwards.
To increase water temperature, turn the handle left, and to reduce – turn the handle
right. Positioning the handle on the extreme left results in the flow of hot water only,
while placing it on the extreme right – the flow of cold water only.
Care and maintenance
Flush with clean water and wipe with a dry, soft cloth.
For heavier deposits, it is recommended to use special tap cleaning agents, prefera-
bly professional Oltens products from the NanoCare and NanoShine series.
Never use agents containing alcohol, disinfectants, solvents and strong bases.
Never clean the surface of the tap with rough cloths or cleaning agents containing
abrasive materials and acids..
Open
Close
On the left:
hot water
On the right:
cold water