To get started,
please visit:
guide.ombea.com.
Turn group feedback
into actionable insights
Please note, as this Pod has
touchless capacity, once it has been
switched on, be careful when
repositioning the Pod for example, to
avoid inadvertently pressing a
button.
Secure the base to the bottom of the
pole with 4 screws (screw A).
Turn the stand the right way up and
secure the vesa bracket on the top of
the pole with the 4 screws provided
(screw A).
ExpressPod EP02L-LITE-FS (touchless)
Assembly Instructions
Secure the ExpressPod to the bracket
with the 4 x screws (screw B) provided.
Check the pod is the right way up. Locate the slider switch on the back of
your ExpressPod.
Slide the switch across so it's in the ‘On’
position - the switch should be
positioned towards the red button.
You will need a small Phillips
screwdriver to assemble your
ExpressPod. A hex key is also
supplied in the packaging.
