OMBEA ExpressTab ET01L-4G-FS User manual

ExpressTab ET01L-4G-FS
Assembly Instructions
BEFORE YOU START
You will need a small Phillips screwdriver
to assemble your ExpressTab.
Secure the base to the bottom of the pole with
4 screws (screw A).
Ensure the USB cable is passed through the
centre of the base and the 2 pins on the
bottom of the pole sit into the corresponding
holes on the base. Leave the cable taped
down at the top of the pole.
Add 1 of the rubber plugs to the hole at
the bottom of the base and feed the
cable through the slit in the plug. Securely
press the plug into the hole.
Turn the stand the right way up and secure
the vesa bracket on the top of the pole with
the 4 screws provided (screw A). Ensure the
cable is not through or under the bracket.
Once secure, add the other rubber plug at
the top of the pole.
Secure the ExpressTab to the bracket
with the 4 x screws (screw B) provided.
Check the tablet is the right way up.
Tip: The stand is heavy and is easiest to secure the screws
while upside down.
Note: please ensure these screws are securely fastened as this
is important to the stability of the stand.
1
2
3
4
Page 1

To get started,
please visit:
guide.ombea.com.
5
6
7
8
Connect the USB cable to the
tablet. The connection is on the
reverse of the tablet, above the
vesa bracket.
Attach the correct adapter to the plug
provided and connect this to the USB
cable at the bottom of the stand.
Switch on the ExpressTab by pressing
on the button at the top of the
ExpressTab.
Slide the question holder tabs into the
ExpressTab enclosure until they click.
Page 2

ExpressTab ET01L-4G-FS
Box contents
Tablet
(secured in plastic enclosure)
Base
Question holder (A4)
Vesa bracket
Top
Bottom
Pole with USB cord inserted
2 x Rubber plugs
8 x screw A
4 x screw B