OutdoorLEDs Dual Wall Light User manual

Dual Wall Light (Square)
Installation and Operating Instructions
the brighter choice

Outdoor LEDs’ Wall Lights offer a stylish and practical way to light up any space, indoor or
outdoor. With the added advantage of reliably projecting light both downwards and upwards
from a compact design, these lights can be incorporated in a variety of places to illuminate any
feature or walkway you should choose. As well as providing beautiful illumination from a stylish
aluminium housing, these wall lights consume only 6 watts, making them one of the most
economic options available.
The Dual Wall Lights use six LEDs, three pointing upwards and three pointing downwards,
per fitting to illuminate your wall. The compact size and stylish aluminium design will transform
the look of dark walkways and add a security aspect when fitted near to doorways and gates.
Dual Wall Light (Square) Kit Contents
• 1x Dual Wall garden Light
• 1x Allen key
1x Fixing kit:
• 3x Fixing screws
• 3x Sealing ‘O’ ring
• 3x Wall plugs for masonry fixing
Safety Note: A qualified electrician must be used to install these products.
2Outdoor LEDs T 01229 484 633 |www.outdoorleds.co.uk

6. Using the baseplate as a template, mark the position of the
three fixing screw holes.
7. Using 5.5mm masonry drill, drill the holes for the screw fixings.
8. Fit the wall plugs.
9. Fit the sealing ‘O’ rings to the screws, fit and tighten the
screws until the baseplate is firmly fixed in place (fig.2).
10. Install the mains supply cable(s) according to the wiring
diagram below. Ensure that the cable grip is fied and fully
tightened.
11. Re-connect the power supply unit output cable.
12. Fit the head unit and secure it in place with the fixing screw.
3
Outdoor LEDs T 01229 484 633 |www.outdoorleds.co.uk
Electrical Installation
The mains power supply for the Dual Wall Light must comply
with the current IET wiring regulations (BS 7671). Specific
recommendations for garden installations are provided in
Chapter 16 of “IET Wiring Regulation Guidance Note 7”.
The electrical supply must be protected by a 30mA
residual current device (RCD).
The Dual Wall Light must be earthed.
The Dual Wall Light baseplate is fied with twin cable grips
which will allow a number of Dual Wall Lights to be connected
to a single circuit in a daisy chain fashion. Use H05RN- F 3 x 1.0
mm2 or equivalent cable (rubber insulated, black neoprene –
suitable for use in wet locations outside).
Cabling must be shielded from prolonged exposure to direct
sunlight and, if it is buried, must be protected against accidental
damage with suitable conduit. Unprotected cables should not
be buried in the ground, nor should they be clipped to wood
fences or similar which may provide inadequate support
and protection.
Installation
Ensure that the power supply is isolated before beginning
the installation.
The Dual Wall Light can be mounted externally, but it is not
intended for immersion in water. We recommend that you wall
mount the lights in a sheltered area at a height of at least
20cm above the height of any potential ground water (fig.1).
1. Using the Allen key provided, remove the screw at the end
of the base of the Light.
2. Separate the baseplate from the head unit.
3. Disconnect the power supply unit output cable by pressing
down on the latch of the quick connector.
4. Put the light’s head unit to one side.
5. Feed the mains supply cable through the entry grommet
and hold the baseplate in position on the fixing surface.
Brown
Green/Yellow
Blue
Fig.1
Fig.2

Disposal of Packaging
Please dispose of all packaging responsibly, recycling where
possible.
Cleaning and Maintenance
Always disconnect from the mains and allow the lights to cool
before cleaning.
Do not use abrasive cleaners on your lights. This may scratch
the finish.
Do not use a pressure washer on these units.
Diagnostics
Q: Why aren’t the lights coming on?
1. In very bright sunlight the garden lights may not appear to
be lit. Check for illumination in darker conditions.
2. Check that the mains supply is switched on and the RCD has
not tripped.
For further assistance, please contact Outdoor LEDs on
01229 484 633.
Guarantee
This product is guaranteed in the UK for a period of one
year from the date of purchase against defective materials
or faulty workmanship. This guarantee is invalid in the case
of improper use, installation, tampering, and removal of the
Q/C date label, installation in an improper working environment
or installation not according to the current edition of the IET
Wiring Regulations (BS7671). Should this product fail during the
guarantee period, it will be replaced free of charge, subject to
correct installation and return of the faulty unit. Outdoor LEDs
accept no responsibility for any installation cost associated
with the replacement of this product. Your statutory rights
are not affected.
Outdoor LEDs reserve the right to alter specifications without
prior notice.
Outdoor LEDs is a division of Marl International Limited, the renowned manufacturers of high quality LED lighting components and systems.
Marl International Ltd Marl Business Park, Ulverston, Cumbria, LA12 9BN, UK
T [phone] |F [phone] |E [e-mail] outdoorleds outdoorleds
Disposal
The crossed out wheeled bin symbol on your product,
literature or packaging reminds you that in the European Union
all electronic products must be taken to a separate collection
at the end of their working life.
DO NOT DISPOSE IN UNSORTED MUNICIPAL WASTE
Technical Specification
Low Voltage Directive: The product is designed to meet
and exceed the requirements of the LVD directive.
Power Supply Specification
Input Voltage: Universal Mains (170 Vac to 250 Vac at 50 Hz)
Rated Power: 6W
Protection: Class:1
Limitations of liability
Marl has taken care to ensure that this product is safe and fit
for purpose. You should ensure at all times that you follow the
installation and aer care instructions detailed in this manual.
Nothing in this manual limits or excludes Marl’s liability for (i)
death or personal injury caused by negligence, (ii) fraudulent
misrepresentation, or (iii) any other liability which cannot be
limited or excluded by applicable law.
Subject to the above, Marl will not (to the fullest extent
permied by law) be liable, whether in contract, in tort
(including, without limitation, negligence), or otherwise arising
out of or in connection with these terms and in particular
where any injury or loss has been sustained through ignorance
of warnings, misuse of goods (including use other than in
accordance with the manual, or unauthorised modifications)
continued use aer a danger became apparent and fair
wear and tear, for any: economic losses (including, without
limitation, loss of revenues, data, profits, contracts, business or
anticipated savings); or loss of goodwill or reputation; or special
or indirect losses suffered or incurred by you arising out of or in
connection with the installation or use of this product.
This does not affect your statutory rights as a consumer.
www.outdoorleds.co.uk
In partnership with