OYPLA Home 3645 User manual

User Manual
USER MANUAL Model No: 3645
4 Bottle Spirit Dispenser

This product is not a toy and should only be used for its designated purpose.
Do not carry out alterations or modifications to this product.
This product is intended for indoor use only.
Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage to product.
Make sure all screws and fittings have been removed from the product carton
before disposing of the carton.
Make sure you secure the product away from electrical wires.
Before using the product, make sure all screws are tightly in place and that
everything is in order, and checked periodically by an adult.
Make sure product is secure before fitting bottles.
Pinch points can cause personal injury.
Do not attempt to exceed the height limit of 35cm (suitable for bottles up to 75cl)
Dispenses 25ml per push. Allow for the dispenser to fill back up before pushing
again to avoid creating a blockage.
This product is for domestic use only.
If using the product for alcoholic beverages, please drink responsibly
(www.drinkaware.co.uk).
If the product is damaged or has any defects, please contact [e-mail]
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold
on this condition, which no representative of the company can waive or change.
USER MANUAL Model No: 3645

Assembly Instructions
Parts List:
If you are missing any of the below parts please contact
cservi[email protected]m
Please be aware that you will be referring to this parts list throughout the assembly process.
4pcs
6pcs
Place the 25ml dispenser into the bottom section of
the dispenser frame (as seen in the picture on the
left) then secure it into place using the quick release
pin as shown by circled part (left). Ensure that the pin
is holding the 25ml dispenser to the frame as if it is
loose this may make any bottles placed onto this
25ml dispenser unstable. Continue to do this with
the remaining 25ml dispensers.
Hold the completed dispenser up against the
desired surface which you want to install it on.
Make sure that the dispenser is flat before
installing. Once you have put it in the correct
position, screw through the holes in the dispenser
frame. Make sure that the dispenser is held tightly
to the wall to avoid the weight of the bottles
moving the dispenser (as seen in the picture on
the right).
USER MANUAL Model No: 3645
25ml Dispenser

Please retain a copy of all instructions for future
consultation.
Imported into the EU by Oypla.com LLP, Uxbridge, UB8 2FX
USER MANUAL Model No: 3645