OYPLA Home 3702 User manual

Ice Drink Dispenser
User Manual
USER MANUAL Model No: 3702

DO NOT EXCEED THE 175KG WEIGHT LIMIT
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
•This product should only be used for its designated purpose.
•This product is intended for indoor use only.
•Do not carry out alterations or modifications to this product.
•This product contains small parts that could be a choking hazard if swallowed. Keep
these items away from children.
•Do not discard any of the packaging until you have checked that you have all the
parts and fittings required.
•Make sure all fastenings are tightly in place and that everything is in order before
using the product. This should be checked periodically by an adult.
•Only use on a stable and level surface.
•Use the correct fixings as indicated. Do not tighten any of the nuts until the unit is
completely assembled, then finish by tightening all nuts. All nuts must be tightened
before use.
•Keep away from fire.
•Don’t drink and drive.
•Clean only with a damp cloth. Do not use strong industrial cleaning substances.
•If the product is damaged or has any defects, please contact cs[email protected]
USER MANUAL Model No: 3702

Operating Instructions
USER MANUAL Model No: 3125
Parts List:
If you are missing any of the below parts please contact [email protected]om
Please be aware that you will be referring to this parts list throughout the assembly process.
USER MANUAL Model No: 3702
Operation Instructions
Fill & Use:
Before first use, wash components thoroughly with warm soapy water as detailed in the cleaning
instructions below.
1. Place the rotating base onto a sturdy, flat surface. Carefully place the beer chamber onto the base
and turn clockwise to lock into place.
2. If using the ice chamber, insert it into the beer chamber and turn clockwise to lock into place. Fill
the ice chamber with ice cubes or crushed ice. Do not fill the ice chamber with water and then
freeze as this will cause the ice chamber to break.
3. Fill the beer chamber to the desired printed line.
4. Replace the lid on the beer chamber and fasten the cap.
5. To use, place a glass underneath the tap & put the tap handle forward to release the liquid.

Please retain a copy of all instructions for future
consultation.
USER MANUAL Model No: 3702
Cleaning Instructions
Note: The tap assembly should not be removed unless necessary (for example blocked by an obstruction)
and should be replaced with caution. To remove the tap, loosen the lock- collar by unscrewing it counter-
clockwise. To replace the tap, screw it clockwise back onto the base & then tighten the lock-collar.
CAUTION: When removing or replacing the tap assembly, to avoid damaging the tap and its parts.
DO NOT OVER-TIGHTEN. Tighten only sufficiently to make a snug seal between the tap and its parts, then
hand tighten the lock-collar.
To Clean:
1. Remove the lid and cap.
2. Remove internal ice chamber by turning it counter-clockwise.
3. Detach the beer chamber from the base by turning it counter-clockwise.
4. Wash lid, cap, ice chamber from the beer chamber thoroughly in warm soapy water.
5. Run warm soapy water through the dispenser while opening & closing the tap.