Oypla Kids 3911 User manual

User Manual
USER MANUAL Model No: 3911
Children’s Table & Chair Set

•This product is not a toy, and is only to be used for its designated purpose.
•This product is only suitable for children aged three and above.
•Never carry out any alterations or modifications to this product.
•This product is intended for indoor use only.
•Only use this product on stable, level and dry ground.
•An adult should assess the area that the table and chair set will be placed to
remove any potential hazards.
•Make sure that a responsible adult checks over the product before each use.
•Make sure all packaging has been removed before attempting to build the
product.
•Do not exceed the 50kg weight limit for the table and chair.
•Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage the product.
•If the product is damaged or has any defects, please contact [email protected]
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold
on this condition, which no representative of the company can waive or change.
USER MANUAL Model No: 3911

USER MANUAL Model No: 3911
Operating Instructions
Parts List:
If you are missing any of the below parts please contact [email protected]om
Please be aware that you will be referring to this parts list throughout the assembly process.

Please retain a copy of all instructions for future consultation.
USER MANUAL Model No: 3911
1. Lay the yellow chair base (part 2) on the floor and slide
a chair leg (part 3) into each hole in the bottom of the
yellow chair base (part 2). Force may be required to
secure each leg into place correctly and ensure that the
table will remain stable. Please see the image to the
right.
2. Stand the chair base up and push the red chair back
(part 1) into the top of the yellow chair base (part 2).
Make sure that the curved section of the red chair back
(part 1) is facing outwards as shown in the image to the
left. Once you have completed this step the chair is fully
assembled.
3. Lay the yellow table top (part 4) on the flat top side
and slide the table legs (part 5) into the holes at each
corner of the yellow table top (part 4). Force may be
required to secure the legs into place correctly. Before
allowing a child to use the product, make sure an adult
has checked over the whole product.