Ozeanos OT-EC-65 User manual
Evaporative cooler
Model OT-EC-65
220-240 V / 50-60 Hz / 65 W
3,5 l water tank capacity
Introduction
Thank you for choo ing an Ozeano product.
Plea e read thi manual carefully before u ing the product.
If you have que tion how to u e the product, plea e don't
he itate to contact u .
Installation and tank filling
Installation
1. Take both part of the ocket and merge them a hown
on figure 1.
2. Undo the crew from the bottom of the product. Merge
the ba e hole and the crew hole of the product. Now
tighten the crew (fig. 2).
3. If you want to eparate the ocket, un crew the ba e
crew and remove the ocket (fig. 3).
Tank filling
Unlock the water tank on the bottom of the back ide. Open the water tank cover, fill the tank with water up
to the marking „MAX“ and then fix the water tank cover again.
Hint for improved cooling capacity:
Take coolpack or fill an ice cube tray with water and put it to a freezer. Take them out when the water i
frozen and add the ice cube or pad to the water tank to improve the cooling capacity.
tarting up
ON/OFF
Connect the power cord of the evaporative cooler to a ocket. Pu h the ON/OFF button to turn the
device on.
SPEED
The evaporative cooler ha three power tage : low / medium / high.
SWING
Pu h the SWING button to tart the automatic o cillation. Pu h the button again to top the
o cillation feature.
COOL/ANION
Pu h the COOL button once to increa e the cooling capacity. If you u e a coolpad, the emanating air
may become cooler.
Double pu hing of the button tart the anion feature for air fre hening.
Triple pu hing of the button combine the cooling feature with the anion feature.
Fourfold pu hing of the button top both feature .
TIMER
The model ha a timer for up to 12 hour . Each pu h of the button increa e the timer for one hour.
Another pu h of the button after reaching the maximum top the timer feature.
MODE
The evaporative cooler ha three kind of wind mode : normal / natural / leep.
Using the remote control
In ert two batterie . The button on the remote control have the ame function a the button on the
control panel. Point the remote control toward the receiver on the device.
ecurity notes
1. Do only operate the device u ing the correct rated voltage (220-240 V).
2. Do not repair the device your elf, let it only be repaired by an authorized technician.
3. Do not operate the device with wet hand to avoid damage.
4. If the power cord i damaged, it mu t be replaced by the manufacturer, ervice partner or a
imilarly qualified per on to avoid danger.
5. If you do not u e the device, turn it off and pull the plug.
6. Do not in ert any object in air outlet or inlet to avoid damage.
7. Do not u e the device clo e to explo ive and flammable ga e . Avoid long-term direct unlight.
8. Do only u e the device on a plane urface.
9. Do not u e the device outdoor .
10. The filling level of the water tank hall never exceed the „MAX“ marking. During cooling the total
filling level of the water tank hall not undercut the „MIN“ marking.
11. Do not lay down the device. If it fall over and water leak into it, pull the plug fir t. Then contact
the ervice department.
12. Clean the urface with a wet cloth. Do not u e trong detergent or lotion . Do not rin e the
device.
13. Do not place the air outlet of the device clo e to wall or curtain .
torage
1. Pull the plug from the ocket and let the device cool down properly.
2. Make ure that all part are clean and dry.
Environment
Do not di po e of the device in normal hou ehold wa te. Bring it to a municipal collection point for
recycling. That way you can add a po itive contribution to protecting the environment.
Warranty and service
If you need help with problem or any other information, plea e u e our web ite or contact u or your eller.
Find out about our entire product range on our web ite.
Ozeano contact data:
Telephone: +49-2154-95365-30
E-Mail: upport@ozeano -cl.de
Internet: www.ozeano -cl.de
