Panasonic WJ-PB65C32E User manual

CAUTION: These servicing instructions are for use by qual-
ified service personnel only. To reduce the risk of elec-
tric shock do not perform any servicing other than that
contained in the operating instructions unless you are
qualified to do so.
•Do not attempt to disassemble the apparatus.
To prevent electric shock, do not remove screws or
covers.
There are no user-serviceable parts inside. Contact
qualified service personnel for maintenance.
•Do not strike or give a strong shock to the unit.
It may cause damage or allow water to enter the unit.
Video Input Board
Operating Instructions
Model No. WJ-PB65C32E
CAMERA IN
IN X-1
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
IN X-2
ALARM IN
VIDEO OUT 2
VIDEO OUT 3
VIDEO OUT 4 VIDEO OUT 1
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
Before attempting to connect or operate this product, please read these instructions carefully and save this manual for future use.
PRECAUTIONS
Along with this document, refer to Matrix Switcher WJ-
SX650 Series Operating Instructions for major operating
REFERENCES
•Pay attention to static electricity
Make certain to keep boards inside the anti-static sack
until it is installed.
Put your hand on a metallic surface, other than the
boards to discharge static electricity before installation.
Do not touch components mounted on the boards
directly by hand.
Hold only both edges of the boards when installing.
controls and their functions, switch settings, and board
mounting procedure.
PREFACE
Video Input Board WJ-PB65C32E is designed for camera
input channel expansion of Matrix Switcher WJ-SX650 Series.

Camera Input (CAMERA IN 1 to 32): 1 V [P-P]/75 Ω(BNC x 32), composite video signal
0.5 V [P-P]/75 Ωdata signal and 2.5 V [P-P]/75 Ωvertical timing pulse multiplexed
Video Output (VIDEO OUT 1 to 4): 1 V [P-P]/75 Ω(25-pin D-sub connector x 4)*, active loop-thru output
Alarm Input (ALARM IN): N.O. (Normally Open contact) or N.C. (Normally Close contact) selectable x 32 (37-
pin D-sub connector)
Dimensions
Main Board: 338 mm (W) X 47 mm (H) X 236 mm (D)
{13-3/10" (W) X 1-9/10" (H) X 9-3/10" (D)}
IN X-2 Board: 355 mm (W) X 21 mm (H) X 117 mm (D)
{14" (W) X 4/5" (H) X 4-3/5" (D)}
IN X-1 Board: 355 mm (W) X 38 mm (H) X 134 mm (D)
{14" (W) X 1-1/2" (H) X 5-3/10" (D)}
* When this unit is powered off, this signal will not be output even with the acceptation of video input signal.
SPECIFICATIONS
STANDARD ACCESSORIES
Operating Instructions (This Document) ................................................ 1 pc.
Screws ..................................................................................................... 7 pcs.
Fixing bracket .......................................................................................... 2 pcs.
Matsushita Electric Industrial Co., Ltd.
Osaka, Japan
http://www.panasonic.co.jp/global/
© 2005 Matsushita Electric Industrial Co., Ltd. All Rights Reserved. NM0805-1105 V8QA6324BN Printed in Japan
FEATURES
•With a set of this board, up to 32 cameras can be
added.
•Up to 32 alarm input signals can be supplied from
alarm sensors connected to the ALARM IN port.
Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households)
This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be
mixed with general household waste.
For proper treatment, recovery and recycling, please take these products to designated collection points, where they will be
accepted on a free of charge basis. Alternatively, in some countries you may be able to return your products to your local retailer
upon the purchase of an equivalent new product.
Disposing of this product correctly will help to save valuable resources and prevent any potential negative effects on human
health and the environment which could otherwise arise from inappropriate waste handling. Please contact your local authority
for further details of your nearest designated collection point.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information.
Information on Disposal in other Countries outside the European Union
This symbol is only valid in the European Union.
If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal.