oIf device is docked to buckle, flip open the device 180 degrees
oIf device is outside buckle, short press Power button
oThe LED should change to Green on for few seconds, indicating call is connected.
-To Reject Call
oLong press function button
oThe LED should change to fast Red flash for few seconds and switch off
During Call
During call progress Green LED will flash slow (very slow flash if call is on phone)
-Volume + or - to increase and decrease volume
-End Call
oPress Power button long press
oIf device is docked to buckle, Flip the dongle back on its park position
oThe LED should change to fast Red flash for few seconds and switch off
-To switch call from device to phone
oPress function button short press during call progress.
-To switch call from phone to device (LED is slow blinking when call is on phone)
oPress Power button short press when call is in phone
Note: If you are using H-band companion “Bluetooth Audio Manager” app on Android phone and the
call is pulled to phone by the app, you need to press the Power button short press twice to get the call
on HBand.
Miscellaneous functions
-To redial previous number: Double press Power button
-For Voice Response (VR) from phone: Long press Power button. This will also invoke smart
functionality on the phone if you are using “Bluetooth Audio Manager” app on Android phone
-Power Off device: Press and hold Power button for more than 5 seconds (until red LED comes
on)
-Factory Reset: Hold Vol- for more than 8 seconds (until red and blue led is on)
Reconnect to your phone
-Press Power button long press
-The device will connect to previously connected phone
-If it does not connect, go to Phone Bluetooth menu and connect the device from phone.
Pairing to New Phone
-Hold Vol- button for more than 5 seconds (until red and blue led start blinking). This will factory
reset the device
-Blue LED will start flashing indicating the device is in Discoverable mode
-Go to Phone Bluetooth menu and connect to available HBandXXXX device
-The LED should flash Green for few seconds and switch off. The Device is now connected to
phone
