Phytec AK-035-1 User manual

A product of a PHYTEC Technology Holding company
AK-035-1
DSP Color CCD Board Camera
Instruction Manual GB
Edition Februar 2001

AK-035-1
PHYTEC Meßtechnik GmbH 2001 L-350e_2
In this manual are descriptions for copyrighted products which are not explicitly
indicated as such. The absence of the trademark () symbol does not infer that a
product is not protected. Additionally, registered patents and trademarks are
similarly not expressly indicated in this manual
The information in this document has been carefully checked and is believed to be
entirely reliable. However, PHYTEC Meßtechnik GmbH assumes no responsibi-
lity for any inaccuracies. PHYTEC Meßtechnik GmbH neither gives any guarantee
nor accepts any liability whatsoever for consequential damages resulting from the
use of this manual or its associated product. PHYTEC Meßtechnik GmbH
reserves the right to alter the information contained herein without prior
notification and accepts no responsibility for any damages which might result.
Additionally, PHYTEC Meßtechnik GmbH offers no guarantee nor accepts any
liability for damages arising from the improper usage or improper installation of
the hardware or software. PHYTEC Meßtechnik GmbH further reserves the right
to alter the layout and/or design of the hardware without prior notification and
accepts no liability for doing so.
Copyright 2001 PHYTEC Meßtechnik GmbH, D-55129 Mainz. Rights -
including those of translation, reprint, broadcast, photomechanical or similar
reproduction and storage or processing in computer systems, in whole or in part -
are reserved. No reproduction may occur without the express written consent from
PHYTEC Meßtechnik GmbH.
EUROPE NORTH AMERICA
Address: PHYTEC Technologie Holding AG
Robert-Koch-Str. 39
D-55129 Mainz
GERMANY
PHYTEC America LLC
255 Ericksen Avenue NE
Bainbridge Island, WA 98110
USA
Ordering
Information: [phone] [e-mail] [phone] [e-mail]
Technical
Support: [phone] [email protected] [phone] [e-mail]
Fax: [phone] [phone]
Web Site: http://www.phytec.de http://www.phytec.com
2nd Edition: February 2001

Features
© PHYTEC Meßtechnik GmbH 2001 L-350e_2 1
1Features:
-Board Size 32x32mm + 42x42mm Stack
-1/3“ CCD Color DSP Camera
-High Sensitivity (0,25Lux at Max Gain +48dB)
-Y/C output as standard
-3 types of External sync. selectable
-Digital Zooming available (Stand. 4x)
-Various mode setting available by Jumper Land
-RS-232C control available through R/C unit
external parameter control (optional):
In delivery condition the camera in automatik mode. It is not external
control necessary.
A separate connector (the cable is not provided with the camera, order
nr.: WK 031) control the camera parameters via an RS232 and PC.
The PC-software (Win9x/Win2000/WinNT, is included with the
cable) loads the settings up to the camera. The settings can be stored
permanently in the camera. The describtion of camera parameters are
in the software manual of control program.
Figure 1: controlprogram for VCAM-1-series

AK-035-1
2PHYTEC Meßtechnik GmbH 2001 L-350e_2
2Specifications (Factory setting mentioned in
Gothic letter):
Image sensor : 1/3” color CCD sensor (Sony ICX-059CK)
TV signal system : PAL
Effective pixels : 752 (H) x 582 (V)
Video Output : VBS (1Vpp, 75 Ohm), Y/C separate
Scanning System : 2 : 1 Interlace
Synchronization : Internal / External
External Sync. : VS/VBS or Sync. or HD/VD or Line Lock
Horizontal resolution : 450 TV lines or greater at Y-signal
Gamma correction : 0.45
Min. Illumination : Standard 0.5 Lux (at AGC=ON +39dB, F1.4)
: Minimum 0.25 Lux (at AGC=ON +48dB, F1.4)
S/N ratio : 50 dB or more (AGC= OFF)
AGC : 39 dB Max. (Analog 24dB + Digital 15dB)
: Selectable 8 modes by Jumper (Max. +48 dB)
Electronic Iris/Shutter : E. Iris ON:1/50-1/30,000sec., FL:1/120sec.,
: OFF:1/50sec., shutter speed settable by Jumper
White Balance : ATW ON (2600oK-9000oK) / OFF / selectable
BLC : OFF / ON (Center) selectable
Temperatures : 0 to +40 deg.C (-5 to +50 deg.C at working )
Storage-Temperatures : -25 to +60 deg.C
Standard Built-in Lens : Fixfocus f=5.6mm F3.0
Dimensions : 42(W) x 42(L) x 34(H) mm
Weigh : Approx. 35 g (with f=5.6mm lens)

Connector Pin Assignment
© PHYTEC Meßtechnik GmbH 2001 L-350e_2 3
3Connector Pin Assignment
CN 5:
1. white Y output
2. white C output
3. yellow IRIS output
4. blue SYNC / HD input (Ext. Sync)
5. black GND
6. blue Ext.-VD input (Ext. Sync)
7. black GND
8. white VIDEO (FBAS) output
9. black GND (DC)
10. red POWER input (DC +12V)
CN 7:
1. GND
2. Remote (RS-232)
11012
JP2
CN2 CN1
JP1 JP3
AK 035

AK-035-1
4PHYTEC Meßtechnik GmbH 2001 L-350e_2
Jumper-land Setting
Function Open factory set 22kOhm short
JP 1 AGC/Gain ON / +39dB OFF ON / +24dB
JP 2 Shutter ON elec. Iris OFF 1/120s fixed ON 1/50s fixed
JP 3 WB/BLC ATW ON
BLC OFF ATW LOCK ATW ON BLC ON
JP 4 Dig. Zoom Stop Tele side Wide side
More adjustments are possible with resistors combinations in jumper
land (OEM).
The connector CN2 in front of the camera, is used for DC-controlled
IRIS (OEM).

Suggestions for Improvement
© PHYTEC Meßtechnik GmbH 2001 L-350e_2
Document: AK-035-1
Document number: L-350e_2, February 2001
How would you improve this manual?
Did you find any mistakes in this manual? page
Submitted by:
Customer number:
Name:
Company:
Address:
Return to: PHYTEC Technologie Holding AG
Postfach 100403
D-55135 Mainz, Germany
Fax : [phone]

Published by
PHYTEC Meßtechnik GmbH 2001 Ordering No. L-350e_2
Printed in Germany