PlayActive BBH118A User manual

-
-The toy should be used with caution since skill is required to avoid
falls or collisions causing injury to the user or third parties.
“Warning.Not to be used in traffic."
WARNING
!
-Examples of safe riding areas.
-A recommendation for adult superision of young children.
-Toys must be assembled by an adult.
-Not suitable for children under 36 moths.
BBH118A BBH118
Our products are suitable for
ASTM F963; GB6675; EN71 and EN62115 standard.
Do not use this vehicle indoors. Using this
Play
Active
outdoor toys for kids
Thank you for choosing a PlayActive product.
We hope your child will endure many years of fun
with this item. If you require any trouble shooting
assistance or help on assembly please view our
tutorial videos available on our website.
www.playactive.net
If you require any further assistance please contact the outlet you
purchased this item from.
vehicle in confined areas may cause the
WARNING!
vehicle's motors to over load.

1 1 0
30
4.5
110 70 53
Training wheels
Round heart cover
4
96
3-6
B. Parts List
36
Plastic wrench
220-240
x2
7
Rear wheel
Mirror
Battery
Backrest
Door window
for model BBH118

29
Flip the body up (people stand in the
front of the vehicle body)
Aligned with the axis of the shaft to the
front wheels catching;
About the same as the front installation
methods;
(Note: Wheels Quick Setup)
1. Install the left (right) front
2. Install the left (right) rear
Flip up the body (human stand in the
rear)
Aligned with the axis of the wheels
catching on to the rear axle;
Left and right rear wheels the same
mounting method;
(Note: the wheel of a key installation)
Toys can t connected to more than the recommended number of power.
Non rechargeable battery can not charge.
Rechargeable batteries can only be used in adult guardianship.
Charge the battery before charging the battery should be removed from the toy.
Battery should be placed in the correct polarity.
The exhausted battery should be removed from the toy.
Power supply terminals shall not be short circuit.
The toy shall only be used with a transformer for toys.
The transformed is not a toy.
The model number or specification of a suitable
transformer for use with the toy.
The toy is disconnected from the transformed before cleaning
Remark:
When the above marking are on the packaging only, it shall also be stated that the
packaging must be retained since it contain important information.

3 8
3. Install the windshield
First remove the screws on the instrument;
The wind rack cards placed on the body;
Then fixed instrument screws;
4. Install the steering wheel
As shown: first of connectors;
Distinguish between the front and rear of
the steering wheel, the steering wheel is
set in rotation rod to the card;
Then 5X40 screws and M5 nut fixed;
/12V
5. Install mirrors
The mirror can be inserted in the body
As shown: distinction mirrors around

7 4
6. Install the backrest and seat
body;
Docking connector plug battery
compartment;
The card is placed on the vehicle seat with
two screws 4 * 12;
As shown: the backrest card placed on the
7. Install strengthening board and
training wheels
As show in figure: remove the screws on
the strengthening board firstly, then fix
with training wheels by the screws.
As shown in figure: remove the screws on the
body firstly, then fix with strengthening board
by the screws.
USING NOTICE of 2.4G remote control is in the back of
the remote control.
1. Remove the door of the 6 screws;
2. Distinguish between the door, put door window on the
bodywork;
3. Screwed again;
8. Install the door window only for
model BBH118.

5 6
Forward / reverse switch
Foot Switch
switch
Light switch
Player
Music keys