Playzone CANTILEVER User manual

ASSEMBLY INSTRUCTIONS - CANTILEVER
PARTS/REQUIREMENTS LIST
1
2
3
7
8
4
6
9
10
11
* Based On Order
** Supplied With Rope Ladder Only
*** Supplied With Trapeze Swing Only
5
Cantilever Parts List
Item Description Qty
1 Cantilever Beam 1
2 Trapeze Swing 1*
3 Pommel Swing 1*
4 Rope Ladder 1*
5 Wooden Peg 2**
6 Swing Hanger 2***
7 M10 x 200mm Coach Bolt 2
8 Fixing Protector Base & Cap Set 5
9 M10 Nyloc Hex Nut 2
10 M10 Hex Nut 2
11 M10 Flat Washer 4
Tools Required
1 13mm Spanner/Crescent/Socket
2 17mm Spanner/Crescent/Socket
3 Level
4 Hammer
5 Ladder
Additional Info
For Safety Reasons, Ensure Cantilever Beam Will
Not Cross Over With Swing Paths Etc.
SHEET 1 OF 2 Version:

B
2
C
D
Pommel Sits On
Knot Tied In End
Of Rope
3
E
F
4
5
A
1
DETAIL A
SCALE 1 : 8
7
8
11
10
DETAIL B
SCALE 1 : 8
The Trapeze Swing
Requires The Supplied
Screw Caribiners To Be
Attached To The
Clipped Caribiners.
The Trapeze Swing
Is Adjusted By Installing
The Screw Caribiner To
A Lower Chain Link.
8
11
9
6
DETAIL C
SCALE 1 : 8
DETAIL D
SCALE 1 : 8
DETAIL E
SCALE 1 : 8
7
M8 Fixings
Packaged With
Rope Ladder
DETAIL F
SCALE 1 : 8
Instruction:
Fix Beam To Tower Holes At
Whichever Position Will Not
Interfere With Swing Beam Or
Monkey Bars As Per Detail A
(Ensure Beam Will Not Cross Over
With Swing Paths Etc).
STEP:
Beam Installation
STEP:
Trapeze Swing Installation
Instruction:
Install Swing Hangers To
Cantilever Beam As Per Detail B.
Instruction:
Tie A Sturdy Knot At The
Bottom Of The Supplied
Rope, Then Feed Rope
Through The Hole In The
Pommel Swing.
Set Swing Height, Then
Tie The Rope Securely
To The Cantilever Beam
STEP:
Pommel Swing Installation
Instruction:
Fix Rope Ladder To Beam As
Per Detail E. Tie The Two Loose Outer
Rope Ends Through The Holes In
The Wooden Stakes. Hammer Stakes
Into The Ground Until They Are Roughly
50mm Above Ground. Bury The Middle
Loose Rope In The Ground.
STEP:
Rope Ladder Installation
SHEET 2 OF 2 Version: