Polaris 2879790 User manual

APPLICATION
Polaris RMK, Switchback and RMK Assault
BEFORE YOU BEGIN
Read these instructions and check to be sure all parts and tools are accounted for.
Please retain these installation instructions for future reference and parts ordering
information.
KIT CONTENTS
This Kit includes:
REF QTY PART DESCRIPTION PART NUMBER
1 4 Carriage Bolt, M6 - 1.0 X 20mm -
2 4 Flat Washer, M6 -
3 4 Handle, M6 -
4 1 Male Buckle, 38mm -
52 Main Plate -
6 2 Side Plate -
Instr 9924828 Rev 02 2016-08 Page 1 of 3
P/N 2879790
ADJUSTABLE GAS CAN HOLDER KIT

Instr 9924828 Rev 02 2016-08 Page 2 of 3
REF QTY PART DESCRIPTION PART NUMBER
7 1 Main Strap -
8 2 ITW Nexus Triglide Adjustment Buckle -
9 1 Female Buckle Assembly -
1 Instructions 9924828
TOOLS REQUIRED
No tools required.
IMPORTANT
Your ADJUSTABLE GAS CAN HOLDER KIT is exclusively designed for your vehicle. Please read the
installation instructions thoroughly before beginning. Installation is easier if the vehicle is clean and free of
debris. For your safety, and to ensure a satisfactory installation, perform all installation steps correctly in the
sequence shown.
ASSEMBLY TIME
Approximately 20 minutes
INSTALLATION INSTRUCTIONS
IMPORTANT
The maximum capacity of the tunnel of the
snowmobile is 6.8 Kg (15 lbs).
1. Insert four carriage bolts qin the tunnel grooves
of the snowmobile, two on each side.
2. Insert the main plates tinto the tunnel, aligning
the bolts in the adjustment slots.
3. Insert the side plates yin the main plates t.
4. Install the four washers wand the four handles e,
do not tighten them firmly.
5. Install the male buckle ron the strap u. Install
the strap on the front and rear using the female
buckle assembly ointo the slots of the main
plates t.
6. Place the can between the plates. Center it on the
tunnel and tighten the plates using the handles e.

Instr 9924828 Rev 02 2016-08 Page 3 of 3
7. Adjust the straps uaccording on the size of your
gas can (A).
IMPORTANT
Buckles must be at the center of the can laid flat.