PolarPlus P12M300 User manual

P12M300 user's manual
Caution:
1. Thank you for purchasing the PolarPlus P12M300. Please refer to
the manual before installation;
2. The installation should be done by the experienced technicians.
Please refer to the manual strictly;
3. Do not open the generator or controller without instructions while
doing the maintenance.
4. Please install the system under no-wind weather.
5. The series are street lighting wind generators and do not
recommend for family power generation.

1. Technical Parameter
Model
P12M300
Rated Power(W)
90
Rated Voltage（DCV）
12
Start-up wind speed （M/S）
1.5
Survival wind speed（M/S）
25
Generator type
PMG
Rotor diameter（M）
0.82
Blade No.（pcs）
6
Blade material
Plastic
Housing material
Aluminum alloy
Controller
Built-in
Slip ring type
Sealed/water proof
Over charging protection
short circuit
Designed lifetime（year）
15
Packing form
Carton
Package size（mm）
455*395*300
2. Power Curve
0
50
100
150
200
250
300
0
2
4
6
8
10
12
14
16
18
20
Power( W)
Wind speed( m/s)
M300

3. Structure
No.
Description
No.
Description
1
Front cover
7
Gyro support
2
Blades
8
Gyro
3
Stator
9
Pressing plate
4
Back cover
10
Back nose cone
5
Clamp
11
Tail vane
6
Slip ring

4. Installation
⚫Connect the cables with the terminal from generator. Please pay
attention to the positive and negative. The cable will be elicited from
the tower.
⚫Connect the small pole and tower with 4 pcs of nuts (M 10*16 ).
⚫Install the blades to the generator with 18 pcs of bolts (M6*28).

⚫Fasten the tail rod, rod plate and gyrator with 4 pcs of screws
(M6*30).
⚫Fasten the gyrator front cover to the back cover via 3 pcs of bolts
(M5*10).

⚫Connect the cable elicited from generator to the battery. (Note: red
for positive and black for negative)
3. Special note:
Connection diagram between wind generator and pole

1. Connect small pole and pipe (48*2.5mm diameter).
2. Drill 2 pcs of symmetrical screw holes (12mm diameter) above a
diatance of 20mm at the upper end of pipe.
3. Clockwise 90°in the hole above the distance of 20mm, and drill 2
pcs of symmetrical screw holes (12mm diameter) above a diatance of
38mm at the upper end of pipe.
4. Fasten the pipe between wind generator and tower with 4 pcs screws
(M10).
Note:
The joints between wind generator and pole need a torque of 80nm.
Fix with locking grain rubber in suitable condition.