Polycom realpresence group convene Owner's manual

www.polycom.com
© 2015, Polycom, Inc. All rights reserved. POLYCOM® and the names and marks associated with Polycom’s products are trademarks and/or service marks of
Polycom, Inc. and are registered and/or common law marks in the United States and various other countries. No portion hereof may be reproduced
or transmitted in any form or by any means, for any purpose other than the recipient’s personal use, without the express written permission of Polycom.
Polycom®RealPresence® Group ConveneTM
Wall Mount Setup Sheet Supplement
For more information about the components of the RealPresence Group Convene, refer to the documentation at
http://support.polycom.com/PolycomService/support/us/support/video/group_series/group_packaged_solutions.html.
1
This product is intended for professional installation by a qualified installer. It is essential to correctly assess the
strength of the wall to ensure that the wall mounting hardware can safely anchor the product. If the installation of the
wall mounting hardware is not done correctly, the product could fall and cause severe injury or property damage.
Polycom is not liable for any injury or damage caused by mishandling or improper installation.
1
Wall Mount Plate
1343-71937-001
Wall Mount Plate Arm
Bracket
1342-71937-001
(2) M4 x 8 Knurled
Thumb Screw
1601-71937-001
Desired Display Height Location
Bottom Face of
Display
Wall Mount Plate
1343-71937-001
Room Wall
3.5”
(88 mm)
This supplement describes how to install the Polycom®RealPresence®Group ConveneTM Wall Mount instead of the supplied
RealPresence Group Convene stand. Refer to the
the Polycom RealPresence Group Convene Setup Sheet for more information.
Supplied hardware for drywall applications
Determine the desired location of the display and the location
of the wall mount plate as shown below.
Drill the mounting holes for the wall mount plate as shown using
the VESA 100 mm x 100 mm hole pattern. If needed, use the wall
plate as a template for drilling the holes.
2
.5”
(13 mm)
.5” (13 mm)
3.9”
(100 mm)
3.9”
(100 mm)
3.5”
(88 mm)
(4) 1/4-20 x 2-1/2”
Hex Head Bolt
1601-61806-001
(4) 1/4-20
Toggle Anchor Insert
1650-28296-001
(4) 1/4“ Washer
1602-61465-001
1725-71937-001A

Polycom® RealPresence® Group ConveneTM Wall Mount Setup Sheet Supplement 2
4
Attach the wall mount plate using the recommended wall
mounting hardware appropriate for your room wall.
Install the wall mount arm bracket
using the two screws (supplied
for mounting the stand to the
display.
Wall Mount Arm Bracket
1342-71937-001
Refer to Step 1 in the Polycom RealPresence Group Convene
Setup Sheet.
6
Fasten the wall mount arm bracket to the wall mount plate using two
thumb screws. You may have to wiggle the bracket to get the screw
to line up with the hole.
(2) M4 x 8 Knurled
Thumb Screw
1601-71937-001
Follow the instructions in the Polycom RealPresence Group Convene
Setup Sheet to install the camera, prepare the codec, connect cables and
install the codec.
Route and manage the cables within the display as needed.
Install the rear cover as shown in the Polycom RealPresence Group
Convene Setup Sheet.
Connect power and power on the system as shown in the Polycom
RealPresence Group Convene Setup Sheet.
Wall Mount Plate
1343-71937-001
3
B
5
Slide the wall mount arm bracket into the wall mount plate.