polyga VISION V1 User manual

QUICK START GUIDE
VISION V1 3D SENSOR
www.polyga.com

GETTING STARTED
Downloading FlexScan3D Software
This quick start guide provides you with the resources to get you started on
3D scanning.
•Factory Calibrated Scanner for capturing 3D data
•FlexScan3D 3.5, SBSDK 3.0 for 3D scanning, mesh processing and
measurement tools.
Instructions for installing and activating FlexScan3D using an installation ID or
dongle can be found in the User Manual
You can download the software from the Polyga Accounts
Page or by contacting your distributor.
To create a download account, please contact us at
Email: [e-mail]
Web: www.polyga.com/contact/
GETTING STARTED
VISION V1 3D SENSOR
• Connect the 3d sensor to the computer via a USB
3.0 A to B cable. Plug in and fasten the 12V DC
power connector. Make sure the port used on the
computer side supports USB 3.0 data transmission
speed. It is suggested to use a powered USB hub
for this connection.
• Turn on the sensor using the back plate button.
The blue LED should light up once the button is
pressed.
SETTING UP THE VISION V1

Open FlexScan3D 3.5 and go to the Scanners Panel tab.
Select the New button to connect to a new scanner.
The software will find all connected scanners, select the corresponding serial number.
Click OK to finish adding the device.
Change to the Project tab on FS3D. Create or open a project to manage your
captured meshes.

Select Handheld Mode to set the scanner to continuous capture.
Place the object being scanned within 400 to 600 mm from the front plate of
the sensor. Change the projector pattern to PHASE/FOCUS for live view with
the scanning parameters.
CONFIGURE SCANNER
Set the gain slider to its lowest value. If the live view still seems to be dark,
slowly adjust the gain value until the live view has proper brightness

Toggle the projector brightness making sure the object of interest is not under-exposed
(blue) nor over-exposed (red).
The object of interest should have a light-grey/white appearance on the live view.
Underexposed live view
Correct live view
Overexposed live view

3.1 Live Point Cloud Visualization
Check the Capture Only option on the left pane.
Click on SCAN to see the live view captured point cloud.
CAPTURE DATA
3.2 Object Reconstruction
Make sure the Capture Only option is unchecked.

Once you are done capturing, click on the STOP button and select YES to save the
resulting point-cloud.
To convert the point-cloud to a mesh, use the Finalize button on the mesh editor to
generate the faces and finalize the raw data.
Select the mesh generation parameters and click OK.

CUSTOMER SUPPORT
After finish getting started with the V1, take the next step using Polyga’s
SBSDK 3.0 to integrate your new 3D Sensor with your application.
For SBSDK information visit : www.polyga.com/sbsdk/
For access to support resources & troubleshooting guides, visit www.polyga.
com/hdi-support-center/
If you have any questions, please contact:
Email: [e-mail]
Phone: [phone]
Web: www.polyga.com/contact/
QUICK START GUIDE
VISION V1 3D SENSOR
POLYGA SB SDK