PondXpert Flowmaster 3500 Setup guide

PondXpert Flowmaster
3500, 4500 & 5000
How to set up your PondXpert Flowmaster Pump

First step
If you look to the front of the
pump you will notice a screw
fit blanking plate.
This inlet is to be used for
cleaning and can be removed
during this time whilst out of
the water.
Within the box there will be the main pump unit and an assortment
of attachments which we will go through in further detail.

Fountain requirements
There is the option to use the Flowmaster
with or without a fountain attachment.

Fountain required
Affix union nut to the top of the unit and turn clockwise to tighten

Fountain required
Attach the ‘T’ piece via
the larger end push
fitment to the union
nut.
This allows the main
fountain attachment
pipe to be added.

Fountain required
This locking nut
needs to be
placed over the
‘T’ piece prior to
the fountain
attachment pole.

Fountain required
1) There should be two poles in the
box with the pump, as shown above.
2) The two poles need to be
pushed together as above.
3) The finished items should look
as above.

Fountain requirement
The fountain attachment
push fits via the larger
end on to the t’ piece
fitment.
The fountain attachments
can be fitted to the top of
the pole attachment.

No fountain attachment
The stepped hosetail can be attached along with the supplied ‘O’ ring to the top of the
unit as shown.
Once the hosetail has been attached this can be adjusted to fit your chosen hose width.

Extra fitments
The extra fitment shown above is to
allow the attachment of lights to the
pond pump; lights are sold
separately.
The fitment slides over the
fountain attachment as shown
above and the lights will clip on if
required.
The lights
required are the
PondXpert
Sublight 20.
These are
provided with
interchangeable
coloured lenses.