Powakaddy ThermaMitts User manual

Thank you for purchasing your PowaKaddy product.
Please follow all instructions for safe use and to get
the best out of your new PowaKaddy ThermaMitts™.
Important
USB-C Trolley Handle
ThermaMitts™
The ThermaMitts™ are only compatible with
PowaKaddy electric golf trolleys tted with USB-C
charging ports on the underside of the handle.
If your trolley does not have a USB-C port, you MUST
use the PowaKaddy PowaPack™.
DO NOT WASH - wipe clean only.
Material: 85% Polyester, 15% PU
For further information, please visit PowaKaddy.com
Product MUST be used with PowaKaddy PowaPack™
Do NOT Plug the PowaPack™ extension cable
directly into trolley.
The ThermaMitts™ have a large current draw not
suitable to PowaKaddy USB-A trolley models and will
cause damage to the trolley handle if this product is
not used as directed.
ThermaMitts™ MUST be used with the PowaKaddy
PowaPack™. Using an adaptor cable to connect the
ThermaMitts™ to the trolley handle directly will
invalidate your electric trolley warranty.
Using the PowaPack™:
1. With your PowaKaddy Electric trolley turned o:
2. Insert the trolley handle grips into the
ThermaMitts™, one side at a time.
3. Slide the grey bungee loops over the grips to
secure.
4. Use Extension cable (provided with the
PowaPack™) to connect the ThermaMitts™ to the
PowaPack™.
USB-A Trolley Range
5. When plugged into the PowaPack™, The
ThermaMitts™ LED button will cycle through the
heat setting colours. Once this has completed,
press, and hold the ThermaMitts™ power button
to power the ThermaMitts™ on.
6. Press the button to toggle through the High,
Medium, and Low heat settings.
7. Place the PowaPack™ in an empty pocket in your
golf bag where it will be secure and completely
dry.
8. Once you have completed your round, power o
the PowaPack™ by double pressing the on/o
button located on the right-hand side.
9. Once home, remember to charge the PowaPack™
and then store in a dry place out of direct
sunlight.
Product can be plugged directly into the trolley
handle.
1. Insert the handle grips into the ThermaMitts™,
one side at a time.
2. Slide the grey bungee loops over the grips to
secure.
3. Plug the ThermaMitts™ USB-C cable into the
trolley charging port.
4. Power on the trolley.
5. The ThermaMitts™ LED button will cycle
through the heat setting colours. Once this has
completed, press, and hold the ThermaMitts™
power button to power the ThermaMitts™ on.
6. Press the button to toggle through the High,
Medium, and Low heat settings.
7. Press and hold the LED button to power the
Mitts o.
Note:
• After 2 Hours, the ThermaMitts™ will
automatically turn o. Simply press and hold the
LED button to turn back on.
• If powering the ThermaMitts™ from the trolley
battery, the total range of the trolley will be
reduced.
Care
TYPE
USB-A
TYPE
USB-C

02689-01-02
PowaKaddy.com
Disclaimer:
PowaKaddy ThermaMitts™ perceived heat
transference will vary depending on the
environmental conditions the product is being
operated in. Wind chill factor, ambient temperature
and user body temperature will all alter the perceived
heat output of the ThermaMitts.