12.
12. Reattach motor cover
Loosen the rear screws of the engine
and put it back in its original position. Then
tighten the front and rear bolts with a torque
spanner. If you have previously removed
your chainring, replace it. Finally, mount
the skidplate.
Once you have nished the instal-
lation, you can place the e-bike upright
again and insert the e-bike battery.
IMPORTANTINSTRUCTIONS
The PowUnity logo on your BikeTrax GPS tracker
should face outward.
Make sure you have good cable management to
avoid bent cables when installing the cable cover.
Tighten the cable tie firmly and shorten
it when you found the optimal position.
Metallic objects and coatings can degrade
the reception of GPS, GPRS and GSM signals.
Therefore, it is important that the BikeTrax GPS
tracker is not hidden inside the e-bike frame or
mounted with the GPS antenna (PowUnity logo)
facing inwards. This can affect performance.
The initial operation of your BikeTrax GPS tracker
should be performed outdoors. This will ensure a fast
connection with good network coverage.
CAUTION: Be sure to follow the warnings marked this
way. The non-observance could result in damage to
property or even personal injury.