Pro DVX GM-75 User manual

ProDVX GM-75 Glass Mount
instruction manual
The ProDVX GM-75 Glass Mounts contains the following parts:
1 x 10” foil / sticker
1 x U-frame (8 x VESA holes)
1 x center block
1x sheet with 2 adhesive strips
4 x short VESA screws (M412)
1 x security screw (cross-recess)

1) Clean the surface with Pro-Screen Cleanerspray
3)Hold the foil on the left side and pull the backside paper out
Place the foil with the desired size on the glass surface
2)

4)Use a solid straight item to even out the foil
5) Even out big bubbles with the straight item (little bubbles will
disappear with time)

6) Gently pull down the paper from the frontside
8)Add the adhesive strips on the backside of the center block
where 7.65 mm is mentioned, and apply good pressure when
sticking the tape unto the backside of the center block.
7)Clean the silver foil/sticker with Pro-Screen Cleaner spray and
let it dry for 3 minutes.

9) Slide the center block with the 2 adhesive strips into the U-frame.
11) Remove the tape from the 2 adhesive strips
Screw the U-frame with the center block in it, on the back of the
ProDVX display using the 4 VESA screws
10)

11) Place the display (with u-frame and centre block) in the middle
of the foil and gently push onto the glass surface to locate the
location of the centre block.
Slide the display (with u-frame) to the top and firmly press the
adhesive centre block in the middle of the foil and let the
centre block rest for 3 minutes.
14) Slide the ProDVX display top-down on to the center block
13)
12)

15) Use a Phillips screwdriver to tighten the long security screw on top
16) The ProDVX GM-75 Glass Mount is now successfully installed