Psion Ikon CH6020 User manual

Page 1 of 2 Part No. 1081132 Revision D
Installation Instruction Ikôn Handstrap & Tether
A. Handstrap Installation
1. Assemble Handstrap to Ikôn handheld by looping Velcro tab around pin and adhering to Velcro pad.
2. Remove bracket and screws from Ikôn.
3. Slide bracket through Nylon Loop on handstrap and install screws.
Adjust handstrap by pulling up Velcro Tab and readjusting to your hand as needed.
1. 2. 3.

Page 2 of 2 Part No. 1081132 Revision D
B. Tether Installation
1. Assemble Tether to Ikôn Telescopic Stylus (a) Thread tether cord through stylus opening. (b) Pull
slipknot on tether through stylus FIRMLY. (c) Make sure metal crimp is flush in stylus opening.
2. Assemble to handstrap (a)Thread tether through eyelet on strap (b) Pass stylus through tether loop and
(c) pull tether snug.
3. Slip stylus into elastic for holder.
(c)(a) (b)
(a) (b) (c)
COMPANY HEADQUARTERS AND CANADIAN SERVICE CENTRE
PSION
2100 Meadowvale Boulevard, Mississauga
Ontario, Canada L5N 7J9
Tel: [phone]
Fax: [phone]
E-mail: [email protected]
www.psion.com
www.ingenuityworking.com