PTZOptics PT-CM-1 User manual

Step 2
What’s Included Fig 1
Rev 2.0
5/14/2020
Mounng Instrucons
Step 1
Hardware for mount ceiling bracket to ceiling .
Wood ceiling— Qty. 4 #10 x 1-1/4” Phillips Pan
Head Sheet Metal Screw (Fig 1, #4)
Dry wall ceiling— Qty. 4 #10-12 x 1” Conical Plas-
c Anchor (Fig 1, #3), and Qty. 4 #10 x 1-1/4” Phil-
lips Pan Head Sheet Metal Screw (Fig 1, #4),
U.S. Single gang device box— Qty. 2 #6-32 x 1”
Phillips Pan Head Machine Screw (Fig 1, #6)
U.S. 4” Juncon box—Qty. 2 #8-32 x 1” Phillips
Pan Head Machine Screw (Fig 1, #5)
European electrical box— Qty 2. M3.5 x 25mm
Phillips Pan Head Machine Screw (Fig 1, #7)
PT-CM-1
Setup Guide Universal Ceiling Mount
#1 #2
#3
#4
#5
#6
Qty. 1 Ceiling Bracket (Fig 1, #1)
Qty. 1 Camera Bracket (Fig 1, #2)
Qty. 4 #10-12 x 1” Conical Plastic Anchor (Fig 1, #3)
Qty. 4 #10 x 1-1/4” Phillips Pan Head Sheet Metal Screw (Fig 1, #4)
Qty. 2 #8-32 x 1” Phillips Pan Head Machine Screw – U.S. box mounting screw (Fig 1, #5)
Qty. 2 #6-32 x 1” Phillips Pan Head Machine Screw – U.S. box mounting screw (Fig 1, #6)
Qty. 2 M3.5 x 25mm Phillips Pan Head Machine Screw – European box mounting screw (Fig 1, #7)
Qty. 3 M3 x 6mm Phillips Pan Head Machine Screw – Safety Screw (Fig 1, #8)
Qty. 1 1/4-20 x 3/8” Philips Pan-Head Machine Screw for Camera Mounting (Fig, #9)
Qty. 2 1/4” USS Flat Washer for 1/4-20 screw (Fig, #9)
#7
#8
#9
Mount Camera to mount (Fig 2, #3) with
included 1/4-20 machine screw. (Fig 1, #
9)
Ulize (0,1,2) 1/4” machine screw at
washers as required. (Fig 1, #9) Note:
1/4” machine screw at washers are to
be used depending upon depth of thread
insert in base of camera, in order to
achieve a snug t.

For more informaon on PTZ Opcs
mounts and other products please visit:
hps://PTZOpcs.com Rev 2.0
5/14/2020
HuddleCamHD
HC-WEBCAM-94
HC-GO
HC-EPTZ-XXX
HC3X-XX-G2
HC3XA-XX
HC3XW-XX-G2
HC10X-USB2-XX
HC10XA-XX
HC10X-XX-G3
HC20X-XX-G2
Mounng Instrucons Connued...
Mount Compability
Step 3
Connect the ceiling bracket (Fig 1, #1) to camera
bracket (Fig 1, #2) with mounted camera by slid-
ing the two brackets together. Screw in the 3
safety screws (Fig 1, #8) to ensure the mounts
do not disconnect.
Other Cameras…
This mount has been
designed for use with most
small based cameras ulizing
a 1/4-20” mounng hole as
can be found on SONY,
Panasonic, Cisco, Polycom
and Vaddio cameras.
PTZOpcs
PT-WEBCAM-80
PTEPTZ-XXX-ZCAM
PTVL-XXX-ZCAM
PT12X-XXX-ZCAM
PT20X-XXX-ZCAM
PT12X-XXX-XX-G2
PT20X-XXX-XX-G2
PT30X-XXX-XX-G2
Safety Screw
Safety Screw
Ceiling Bracket
Camera Bracket