CONEN SCETTACM25BK User manual

1
ASSEMBLY INSTRUCTION
Mini convertible Mobile Stand
with anti-collision
Conen Produkte GmbH | Conenstr. 4 | 54497 Morbach-Gonzerath | Germany | [phone] I www.conenmounts.com
SCETTACM25BK
CONEN/01/2020

2
1
2
3
A A
1
2
B
3
C
5
44
5
PACKAGE CONTENTS
Lenshead Allen screw
Depending on the display
Mini tiltable mobile Stand
Remote control
Power cable
3 x
Cable clamp
Anti-collision sensor
Control unit
4 x M8 x 20 4 x M6 x 20 3 x
Cable fixing clip
Conen Produkte GmbH | Conenstr. 4 | 54497 Morbach-Gonzerath | Germany | [phone] I www.conenmounts.com

3
12
4
A
3
2
3
1
2
B
D
A
C
5
MOUNTING INSTRUCTIONS
For moving the unit up or down just press and hold the buttons
on the control unit. Releasing the button will immediately stop the
movement. So in case of emergency just unhand the control unit
(watchdog switch).
Height adjustable Tiltable
AUp CVertical position
BDown DHorizontal position
Conen Produkte GmbH | Conenstr. 4 | 54497 Morbach-Gonzerath | Germany | [phone] I www.conenmounts.com

4
9
8
A
A
76
11
10
MOUNTING INSTRUCTIONS
Conen Produkte GmbH | Conenstr. 4 | 54497 Morbach-Gonzerath | Germany | [phone] I www.conenmounts.com

5
13
12
AA
14 15
B
C
16
MOUNTING INSTRUCTIONS
Conen Produkte GmbH | Conenstr. 4 | 54497 Morbach-Gonzerath | Germany | [phone] I www.conenmounts.com

6
2
B
D
A
C
2
1.1
2
1.4
5
4
1.3
5
1.2
2
4
3.1 3.4
4
3.3
5
3.2
2
5
2
4
TROUBLE SHOOTING
Trouble Shooting:
1Press key and simultaneously until you
hear 1 x audio signal
2Press key until you hear 3 x audio signal
3Press key and hold on until the column
reached the maximum position and you can
hear 2 x audio signal.
System is pre-calibrated.
PLEASE RECALIBRATE ONLY IN CASE OF
ERROR.
Conen Produkte GmbH | Conenstr. 4 | 54497 Morbach-Gonzerath | Germany | [phone] I www.conenmounts.com

7
MOUNTING REGULATIONS
ELECTRICAL SAFETY
Connect unit to a free accessible 110 - 230 V / 50 - 60 Hz grounded power outlet only.
Make sure, the unit can be immediately separated from the power outlet. Only use unit in dry
rooms, protect unit from water and other liquids. Only wipe unit with dry cloth. Do not open lift
unit. RISK OF ELECTRIC SHOCK. There are no serviceable parts inside. In case of disfunction
unplug unit from power outlet and call an authorised technical service person. Do not overrun
power cord or damage in any other way. Replace damaged line cords immediately with new
one from same type.
The socket connections of the unit and the wall socket must be easily accessible.
The device is not dripping or splash water protected. Do not place objects lled with liquids
on or spray the device.
GENERAL HINTS FOR MECHANICAL SAFETY
Do not improperly load unit. Do not hang on unit. VERY HEAVY UNIT. Se-
vere risk of injury when unit falls over due to improper usage. Only use
original mounting parts provided with the system. Max load of lift unit is 150 kg / 330 lbs.
Do not exceed. Assure installation of unit by authorized service person only. Before moving the
unitupordownashureatleastasafetydistanceof20cm/7.9"fromanypartoftheunittoanyother
tment in order to avoid shear traps or squeezing points. In case of accident please release
operating panel. Movement of unit will stop immediately.
SPECIAL HINTS FOR WALL MOUNTED UNITS
Use appropriate wall mounting material only. Choose douwels and screws according to the
wall type and material. Using improper mounting material may result in tilting of the unit and
severe risk of injury. Wall mounting must be done by experienced personal only.
INSTRUCTIONS FOR DISPOSAL
Do not dispose to consumer waste.
IMPORTANT HAZARD & SAFETY NOTES
Please carefully read the below hazard and safety notes before using the height adjustment unit. This adds
to make the unit work failure-free and avoids accidents.
Conen Produkte GmbH | Conenstr. 4 | 54497 Morbach-Gonzerath | Germany | [phone] I www.conenmounts.com

8
Conen Produkte GmbH | Conenstr. 4 | 54497 Morbach-Gonzerath | Germany | [phone] I www.conenmounts.com